Cylinder - part of combustion engine, Mechanical Engineering

Cylinder - Part of combustion engine:

Cylinder:

It provides cylindrical closed space to allow movement of piston and to admit charge. It is made up of grey cast iron or iron alloyed with other elements such as nickel, chromium etc. The fuel is burnt inside the cylinder. The internal diameter of cylinder is called as bore.

 

 

Posted Date: 10/20/2012 3:56:13 AM | Location : United States







Related Discussions:- Cylinder - part of combustion engine, Assignment Help, Ask Question on Cylinder - part of combustion engine, Get Answer, Expert's Help, Cylinder - part of combustion engine Discussions

Write discussion on Cylinder - part of combustion engine
Your posts are moderated
Related Questions
A pump is used to deliver discharge of 0.05 m 3 /s from a river to a storage reservoir. The system consists of 500 m of 0.15 m cast iron pipe with a 90 o bend with a rad

Natur e of Distribution of Bending Stress Figure Nature of stress distribution in section of a beam It will be proved that bending stress at any layer of section o

Q. What is Hydrostatic extrusion? • In the hydrostatic extrusion process the billet is completely surrounded by a pressurized liquid, except where the billet contacts the die.

If Battery Discharges Frequently Causes of Problem Remedy Electrolyte specific gravity NG Charging not done fully

Open belt drive: An open belt drive connects the two pulleys 120cm and 50cm diameter on parallel shafts which are apart 4m. The maximum tension in belt is 1855.3N. Coefficien

There are five elastic properties needed to represent the elastic behaviour of a unidirectional laminate under in-plane loading, but only four of these are independent. The five

Application of Drilling machine Drilling machines of dissimilar capacity and configuration are basically used for originating cylindrical holes and occasionally for enlarging t


Complaints of Engine Starting: If there is a problem related to the starting of the bike, it can be due to mechanical as well as electrical reasons. The possible reasons could be

A manufacturing facility consists of five departments, 1, 2, 3, 4 and 5. It produces four components having the manufacturing product routings and production volumes indicated in t