Composite Materials, Mechanical Engineering

One can increase the toughness of a ceramic material by introducing fibers to the structure of the ceramic and create a ceramic-matrix composite. However, unlike other fiber-reinforced composites, in this case the bonding between the matrix and fiber should not be very strong. Explain how this process toughens the ceramic material.
Posted Date: 3/11/2013 2:03:03 AM | Location : Malaysia







Related Discussions:- Composite Materials, Assignment Help, Ask Question on Composite Materials, Get Answer, Expert's Help, Composite Materials Discussions

Write discussion on Composite Materials
Your posts are moderated
Related Questions
TYPES OF ELECTRON BEAM WELDING GUN   Diode (Cathode - anode) Gun : In this gun, the beam shaping electrode and the emitter are both at the same electrical potentials. These

parameters in designing a presure vessels

I need chart for speed/feed/depth of cut for general milling

Carbides Carbides of titanium, zirconium, boron and silicon are significant refractory materials. Though, the carbides have extremely high melting points so they lack oxidatio

Method of resolution to find out the resultant force: Some time there is doubt for finding the angle of resultant (θ), the value of the angle θ will be very depending upon the

Cylinder Bore: The nominal inner diameter of the working cylinder is called the cylinder bore and is designated by the letter D and is usually expressed in millimetre (mm).

ESSENTIAL S OF A GOOD BOILER: -     Should be capable of producing the required Steam at   the required pressure for minimum fuel required. -     Should be capable of stan

Q. How can you implement Permeability test  As already defined, permeability of porosity of the moulding sand is the message of its ability to permit air to flow through it.

Multimeter: This is used to measure voltage, current and resistance of an electrical circuit (Figure). Figure: Multimeter

(a) Oil, with density ρ= 900 kg/m 3 , and kinematic viscosity υ=0.00001m 2 /s, flows at the rate of 0.2m 3 /s through 500m of a cast iron pipe of diameter d=200mm. Using this infor