Complete instruction set of 8085 microprocessor , Electrical Engineering

Complete Instruction Set of 8085 Microprocessor

There are  total 256 instructions in  8085 microprocessor. These instructions are classified  into  seven categories  according  to their  functions these are :

a.Data copy  operations

b.Input output  operations

c.Arithmetic  operations

d.Logical  operations

e.Branch operations

f.Machine  control operations

g.Stack operations

To define  the format  of various  instructions followings variable names  and symbols  are used.

In order to understand  and write  assembly  language  program it is necessary to learn various  type of instructions and  also what  changes can be  made in registers and  flags by each  instruction after  execution.

Readers  who are  studying  microprocessor  for the  first  time are  advised to kip  the  instruction market  as they  might  be difficult to understand  at this  moment.

The above  mentioned  seven  categories  of instructions are discussed  in the followings  sections.

Posted Date: 4/4/2013 3:55:40 AM | Location : United States







Related Discussions:- Complete instruction set of 8085 microprocessor , Assignment Help, Ask Question on Complete instruction set of 8085 microprocessor , Get Answer, Expert's Help, Complete instruction set of 8085 microprocessor Discussions

Write discussion on Complete instruction set of 8085 microprocessor
Your posts are moderated
Related Questions
On which principle the generator works?

#question ...THE APPLICATION AND OPERATION OF ZENER DIODES

Give the register organization of 8257? The 8257 do the DMA operation over four independent DMA channels. Each of the four channels of 8257 has a couple of two 16-bit registers

Unconditional Jump JMP ( Unconditional Jump ) Instruction: This  instruction is used to transfer  the execution to the  specified  memory  address unconditionally ( does not c

A rifle with a mass of 3,5 kg fires a bullei with a mass of 120 g with a muzzle velocity of 420 mls. Calculate the following: 1.4.''l The momentum before the rifle was fired ''1.4.

matlab program for verifying maximum power transfer

The purpose of this experiment is to introduce you to a powerful 80x86 assembly/machine language utility called DEBUG. Preparing Your DEBUG Environment If you have an older

Q. Determine the Thevenin resistance viewed from terminals A-B of the circuit of Figure by setting independent sources to be zero and applying a test voltage at terminals A-B.

A single-phase source delivers 100 kW to a load operating at 0.8 lagging power factor. In order to improve the system's efficiency, power factor improvement (correction) is achieve

1. An analog information signal, whose maximum frequency is 6000Hz, is to be transmitted using a PCM system. The quantization error must not exceed the 1 % of the peak-to- peak an