## calulation of hv/lv ratio to reduce the line loss, Electrical Engineering

Assignment Help:
kindly send us the formula and C program for performance improvement of distribution system using HV/LV ratio.
REGARDS
ANUJ AGARWALA

#### Explain contact resistance, Explain Contact resistance. Contact resista...

Explain Contact resistance. Contact resistance: It is measured as the voltage drop from tail to tail of the mated contacts along with specified current flowing through the cont

#### Compute the worst voltage regulation, Q. The following data were obtained o...

Q. The following data were obtained on a 25- kVA, 2400:240-V, 60-Hz, single-phase distribution transformer: • Open-circuit test with meters on LV side: 240 V, 3.2 A, 165 W •

#### A transistor has how many p-n junction, A transistor has (A) One p-n j...

A transistor has (A) One p-n junction.  (B) Two p-n junction. (C) Four p-n junction. (D) Five p-n junction. Ans: A transistor has two p-n junctions.

#### Closed loop block diagram into Electrical Circuit, I have a closed loop or ...

I have a closed loop or feedback system and i want to convert it into electrical circuit. please give me example about this

#### Alternator, How can I design alternator?

How can I design alternator?

#### Jfet ampli?er circuit, Q. For the CS JFET ampli?er circuit of Figure, R D ...

Q. For the CS JFET ampli?er circuit of Figure, R D = 2k and R L = 3k. The JFET with ro = 15 k has a voltage gain A v1 =-4.5 when the entire source resistance is bypassed. Fin

#### Automatic irrigation system on running solar power b, how to upload the pro...

how to upload the program on proteus software by using personal computer

#### Find the highest speeds at which linkage would be possible, Q. Two coupled ...

Q. Two coupled synchronous machines are used as a motor-generator set to link a 25-Hz system to a 60-Hz system. Find the three highest speeds at which this linkage would be possibl

Explain relative data addressing mode (with examples) available in microprocessors. Relative Mode: Operand supplied is an offset, not the actual address. Added the con

#### Determine the maximum value of the voltage induced in coil, Q. A 10-turn sq...

Q. A 10-turn square coil of side 200 mm is mounted on a cylinder 200 mm in diameter. If the cylinder rotates at 1800 r/min in a uniform 1.2-T field, determine the maximum value of  