Calculate the moment of inertia , Mechanical Engineering

Calculate the centroid (use point A as the reference) and the moment of inertia of the shape shown in Figure. The dimensions are given in centimeters. 

1416_Calculate the moment of inertia.png

Calculate the moment of inertia about the X-axis for the shape shown in Figure. The centroid of the shape is located 8.5 cm to the right and 19.9 cm above point A.

2475_Calculate the moment of inertia1.png

Posted Date: 2/18/2013 4:40:12 AM | Location : United States







Related Discussions:- Calculate the moment of inertia , Assignment Help, Ask Question on Calculate the moment of inertia , Get Answer, Expert's Help, Calculate the moment of inertia Discussions

Write discussion on Calculate the moment of inertia
Your posts are moderated
Related Questions
Calculate the Length of Developed Blank Part shown in Figure is to be produced from flat sheet by bending operation. Calculate the length of the developed blank. Assume k = 0.

Deflection at the centre: A simply supported beam of span 6 m is subjected to Udl of 24 kN/m for a length of 2 m from left support. Discover the deflection at the centre, maxi

Newer Approaches To On-Line Scheduling  The on-line scheduling has established to be superior option than off-line scheduling upon the shop floor. The on-line scheduling looks

Tyre: Different bikes respond differently to different tyres, so it is impossible to make a generic recommendation. It mainly consists of outer cover and inside tube. The tyre tub

Q. Benefits of a good layout and design? The benefits of a good layout and design cannot be overemphasized. They provide an irreplaceable safety factor throughout the life of t



Q. Horizontal Vessels and Vertical Vessels? Horizontal Vessels A horizontal vessel, designed to support a full weight load of water, shall be tested while resting on its sup

Determine reactions of the overhanging beam: Determine r eactions at points A and B of the overhanging beam as shown in the figure given below.

The following data was obtained from an orthogonal cutting test : Rake angle = 20o, Depth of cut = 6 mm Feed rate = 025 mm/rev Chip length before cutting = 29.4 mm Chip