Calculate the antenna aperture area, Electrical Engineering

Q. Amicrowave relay systemuses two identical horn antennas mounted on towers spaced 40 km apart. If fc = 6 GHz, and each relay hop has L = 60 dB, calculate the antenna aperture area Ae in square meters.

Posted Date: 6/14/2013 4:15:19 AM | Location : United States







Related Discussions:- Calculate the antenna aperture area, Assignment Help, Ask Question on Calculate the antenna aperture area, Get Answer, Expert's Help, Calculate the antenna aperture area Discussions

Write discussion on Calculate the antenna aperture area
Your posts are moderated
Related Questions
if a resistor present in the middle of two branches in such a way that their polarities coincide then how do we choose the polarity of that resistor

an ideal dc generator has voltage reguiation

GIS Benefits: Improving financial viability. Reduction of T&D losses. Improving customer satisfaction. Raising reliability of power supply. Improving qual

Singles Phase  Half wave Controlled Rectifier  with RL Load When gate pulses are applied to the thyristor  at output voltage  v0 follows the input voltage  v s ( = V m sin ) s

What is memory mapping? The assignment of memory addresses to several registers in a memory chip is known as memory mapping.

Design the Synchronous Sequential Circuit for State Diagram Illustration: - We wish to design the synchronous sequential circuit whose state diagram The kind of flip-f

Assume that an abrupt Si p-n junction with area 10-4 cm2 has NA=10 17 /cm 3 and ND=10 17 /cm 3 is working at room temperature. It is given that μ n = 700 cm 2 /v-s, μ P =250 cm

Q. Illustrate Signal attenuation? Signal attenuation in many channels can be offset by using amplifiers to boost the signal level during transmission. However, the amplifier al

Q. Explain the Importance of distributing frames? Basically four levels of cabling are used as displayed in Figure. At the subscriber end, drop wires are taken to a distributio

What is ammeter An ammeter is an instrument used to calculate current and must be connected in series with the circuit.