Calculate the angular deflection produced in a solid , Mechanical Engineering

Calculate the angular deflection (in degrees) produced in a solid circular shaft of diameter 12.5mm and length 0.5 m when the shear stress is 25MPa and the shear modulus 70GPa. What torque would be required to achieve this?

Posted Date: 3/12/2013 6:50:48 AM | Location : United States







Related Discussions:- Calculate the angular deflection produced in a solid , Assignment Help, Ask Question on Calculate the angular deflection produced in a solid , Get Answer, Expert's Help, Calculate the angular deflection produced in a solid Discussions

Write discussion on Calculate the angular deflection produced in a solid
Your posts are moderated
Related Questions
A pump station has been designed to lift water out of a 6 metre deep pit (vented to atmosphere) via a centrifugal pump mounted at ground level. Liquid conditions

Q. Describe the Insulation thickness? Insulation thickness shall be selected in accordance with the following tables forming part of this specification: Table I Outdoor Hot

How can i change the normal function block parameter[1 1]=>(s+1) to (s-1)?

Engine oil replacement Motorcycle is thoroughly drained by kicking the vehicle several times. Inspect the drain bolt washer and replace if necessary. Tighten the drai

• IGF Vessel SH: CS + 1.6 mm CA + Internal Coating Eductor: 304L SS or alternatively, 12Cr • ORF Vessel SH: CS + 1.6mm CA + Internal Coating Mixer: 316L SS • Skim Oil T

General Resource Models In  computer  controlled scheduling,    material,  machine handling  equipment,  tooling  and  buffer  space  should  be comprised. The explicit consid

T emperatur e Measurement by Using Thermometers: To measure temperature at temperature scale should be devised assigning arbitrary numbers to a known specific level of hotne

DRIVESHAFT SEALS Packed gland Sealed by several layers of asbestos or cotton yarn     Sometimes used two boxes with intervening space separated by steam Problems:     T

Welding transformer The resistance welding transformers step down the line tune of 2 to 20 V. The primary is connected to the line supply and is made from edge bent copper stri

There is risk of wet H 2 S corrosion in all emulsion and gas lines from the Inlet Separator up to and including the Treater. Full compliance to NACE is highly recommended to contro