blasting, Other Engineering

Assignment Help:
Students are to undertake a tunnel blast design for the following conditions:
• Tunnel is 5.5m wide by 5.5.m high
• Rock is a granite with a UCS of 300 MPa
• Drill hole diameter is 51 mm, hole length is 4m
• The cut is to contain 2 relief holes of 75mm diameter
• Dry conditions are anticipated, ANFO to be used with a density of 800 kg/m3 and a powder factor of 0.6 kg/m3
• Nonel detonators are to be used

Related Discussions:- blasting

Deadlock based problem in operating system, Deadlock based problem in opera...

Deadlock based problem in operating system# Deadlock usually occurs between a known set of processes that end up waiting on each other. If we cannot prevent or avoid deadlock, anot

Vertical spread, what are the no-arbitrage lower bound of the vertical spre...

what are the no-arbitrage lower bound of the vertical spread

Testing of propellers, Testing After Install After installation of a pro...

Testing After Install After installation of a propeller, the engine must be ground run in order to check the propeller for correct function and operation.  Aircraft propeller in

Laurent polynomial, how to perform division of two laurent polynomials?

how to perform division of two laurent polynomials?

Control surface effectiveness and reversal, Control Surface Effectiveness a...

Control Surface Effectiveness and Reversal To discuss the effectiveness and loss of a control surface, we allow a rigid rotation δ of the flap set by a flight control system (o

Aircraft controls, The aerodynamic flight controls of a typical aeroplane ...

The aerodynamic flight controls of a typical aeroplane include ailerons (British: ξ ("Xi"); US: da or δa), elevator (British: η ("eta"); US de or δe), and rudder (British: ζ ("zeta

Extended input facilities, Extended input facilities Another instance w...

Extended input facilities Another instance where multiple inputs to a single gate operation can occur is with certain types of gate elements that have an 'EXTENDED INPUT' facil

Thrust indication - aircraft engine, Thrust indication: Although rpm ga...

Thrust indication: Although rpm gauges give an indication of the rotational speed of the compressor, they do have one drawback. They do not normally indicate the thrust output

Hot and cold working, advantages and disadvantages of cold and hot working

advantages and disadvantages of cold and hot working

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd