Beam reactions, Mechanical Engineering

i would like to know how much it would cost to for my assignment without the actual graphs but the dimentions and without the assignment being converted into a word document as long as its legibly written?. Thanks
Posted Date: 11/15/2012 2:34:59 AM | Location : United Kingdom







Related Discussions:- Beam reactions, Assignment Help, Ask Question on Beam reactions, Get Answer, Expert's Help, Beam reactions Discussions

Write discussion on Beam reactions
Your posts are moderated
Related Questions
constructing and working of he- ne laser

Structural notches In t he case of solid solution strengthened alloys and age hardenabled steel, the variation in heat i/o during welding may cause localized grain coarsening o

Q. Show Hazard assessment of plant operation? Using the hazard assessment of each plant operation will help establish the layout or orientation of process units within the plan

Problem A cat walks along a uniform plank that is 5.00 m long and has a mass of 9.00 kg.  The plank is supported by two sawhorses, one 0.500 m from the left end of the board a

High Speed Circuit : The speed of motorcycle is further increased by raising the throttle valve. In this condition, fuel and air enter through main passage and main jet as can be

Find out maximum stress and elongation of the bar: A rectangular bar having uniform cross-section of 4 cm × 2.5 cm and of length 2 m is hanging vertically from rigid support.

Construct a plain scale: The distance between Indore and Bhopal is 180 kilometer. It is represented on the map via 9 centimeter. Construct a plain scale for such map, illustra

The transmission output shaft for a heavy goods vehicle can withstand a safe working shear stress of 54MPa. Its outside diameter is 54mm and its internal diameter is 48mm. Calculat

Determine the normal stresses: A short hollow pier 1.6 m × 1.6 m outsides as well as 1.0 m × 1.0 m intersides supports a vertical load of 2000 kN at a point located on a diago

Define 3-D lathe Tool Dynamometer It is possible to measure three dimensional cutting tool component with the help of 3-D lathe tool dynamometer. In spite of that we are gone f