## Air injection system and solid injection system, Mechanical Engineering

Assignment Help:

(a) Explain a typical fuel feed system for a C.I engine, differentiate between air injection system and solid injection system.

(b) Why Gasoline injection system has been adopted now a days ? What are the different process of petrol injection.

#### Mechanisms, two different method to convert from rotational motion to linia...

two different method to convert from rotational motion to liniar motion

#### Surface modeling, SURFACE MODELING: The process of modeling is built m...

SURFACE MODELING: The process of modeling is built much easier for a mathematical description of an object or at least on a part of the object might be applied. Surfaces might

#### General reasons for defects, GENERAL REASONS FOR DEFECTS The imp...

GENERAL REASONS FOR DEFECTS The importance of weld quality is increasingly felt as we go ahead with the fabrication of sophisticated products using higher strength mater

#### Fluid mechanics, A cart is moving along a track at a constant velocity of 5...

A cart is moving along a track at a constant velocity of 5 m/s as shown. Water (? = 1000 kg/m3) issues from a nozzle at 10 m/s and is deflected through 180° by a vane on the cart.

#### Air transportation, AIR TRANSPORTATION: Air transportation has grown r...

AIR TRANSPORTATION: Air transportation has grown rapidly all over the world and in India too. Its main advantages are speed, good safety record, military use, ability to serve

#### Plot the root locus diagram for a system, Plot the root locus diagram for a...

Plot the root locus diagram for a system whose open loop transfer function is Evaluate the range of values for K for system to be stable.

#### Theory of machine, write short note on''coefficient of insensitiveness''of ...

write short note on''coefficient of insensitiveness''of governors.

#### Determine sliding velocity, a) A pair of 20 degree full depth involute spur...

a) A pair of 20 degree full depth involute spur gears having 30 and 50 teeth respectively of module 4mm are in mesh. The smaller gear rotates at 1000 rpm. Determine- 1) Contact

#### Thermodynamics, when does water convert in to ice at vaccum pressure

when does water convert in to ice at vaccum pressure

#### Quality of welds produced by submerged arc welding, a) You have been assign...

a) You have been assigned to design a robotics spot welding experiment for low carbon steel sheets. You found an experimental power source for spot welding process which is designe