Advanced interface module and system bus, Computer Networking

Advanced Interface Module (AIM) socket

This is an 100 pin internal socket. It is provide for plug in the Advance interface module card. Purpose of AIM card is concentrate in the data compression,encryption, decryption  and so on without help of external requirement

HOST PCI Bridge

It act as a bridge between system bus ,CPU bus , PCI bus. Network modules and interface boards are connected in PCI bus.

System Bus.

Communicating between  the CPU board and interface boards. in 2600 series, PCI bus provides for this communications between these two boards

 

Posted Date: 3/5/2013 6:58:52 AM | Location : United States







Related Discussions:- Advanced interface module and system bus, Assignment Help, Ask Question on Advanced interface module and system bus, Get Answer, Expert's Help, Advanced interface module and system bus Discussions

Write discussion on Advanced interface module and system bus
Your posts are moderated
Related Questions
Q. Explain the types of Security Threats? (a) Normal Flow (b) Interruption: An asset of a system develops into unavailable or unusable. (c) Interception: A few unaut

The address recorded by a router should be its outgoing interface. That is, if a router forwards a datagram that has the record route option enabled, and if the datagram arrives at

Question 1 What are the aspects you should consider while creating a showreel? Question 2 What are the different patterns of writing a resume? Elaborate each of them wit

Recognize the command to configure a explanation on an interface Ans) Router(config-if)# explanation Finance department

State the uses of groupware With the use of groupware, users can easily do most of the office related management work, which otherwise would be extremely difficult. For instanc

Network throughput It is a symptomatic measure of the message carrying capability of a network. It is termed as the total number of messages network can send in per unit time.

Explain Bus Topology. The physical Bus topology is the easiest and most widely used of the network designs. It having of one continuous length of cable (trunk) and a terminatin

The goal of this assignment is to provide an exposure to Network and System Administration issues. For the project, you are required to design/configure/implement/test/review a Net

ETHERNET FIELDS:  In Ethernet fields the preamble and CRC is usually not given in frame. The destination address of each is the broadcast address. There is special value reser

What is the difference between CSMA/CD and CSMA/CA? CSMA/CD, or Collision Detect, retransmits data frames when a collision occurred. CSMA/CA, or Collision Avoidance, will first