A/D conversions, Assembly Language

A/D conversion:

Basic tasks:
(a) Write a program that will read and display the analog voltage on
pin PE7 approximately once every second.
(b) Write a program that will read and display in decivolts the analog
voltage in pin PE7 approximately once every second.
(c) Write a program that will read and display in decivolts using decimal
representation the analog voltage on pin PE7 approximately
once every second. Make sure your output has a decimal point
after the first digit so your output reads something like:
1.2 V
Additional task: In addition to displaying the voltage to the screen,
output the voltage to the LCD screen. (LCD display routines are provided for you.)
(Make sure there is only one value of the voltage displayed and that it is updated every second.)

Note: Parts (a), (b), (c) represent progressively more difficult requirements.
Full points are given for a solution to Part ( c).
Posted Date: 7/9/2012 9:13:31 PM | Location : United States







Related Discussions:- A/D conversions, Assignment Help, Ask Question on A/D conversions, Get Answer, Expert's Help, A/D conversions Discussions

Write discussion on A/D conversions
Your posts are moderated
Related Questions
CALL : Unconditional Call:- This instruction is utilized to call a subroutine from a basic program. In case of assembly language programming, the term procedure is utilized int

Write a program to evaluate the following expression. You are to evaluate the following equation: num1 - (input + num2) - (num3 + num4) Input will be a hex number input by

I can get it to copy the string but can''t get it to reverse it.

Addressing mode of 8086 : Addressing mode specify a way of locating operands or data. Depending on the data types used the memory  addressing  modes and in the instruction  ,

AAM: ASCII Adjust for Multiplication after execution. This instruction converts the product available in the AL into unpacked BCD format.  This follows a multiplication   instruct

check the al-register for palindromic number

1. Start your program at address $8500. To do this you need to inform the assembler, through the EQU and ORG assembler directives, that you want your program to start at $8500. Thi

Signal descriptions of 8086 : described below are common for the maximum andminimum mode bothdata lines AD15 -AD0: These are the time multiplexed andmemory I/O address. Addre

(1) Write a program that will: (a) display "Enter Your Name:" (b) convert the entered name to Capital letters (if small), If any other character is entered, the program wil

A/D conversion: Basic tasks: (a) Write a program that will read and display the analog voltage on pin PE7 approximately once every second. (b) Write a program that will read and d