calculate the shear stress and angle-open square tube, Mechanical Engineering

The open square tube is subjected to the torque T= DEF Nm as shown in Fig Q2. The tube has the length 1m and wall thickness 5mm.

a)  Calculate the shear stress and angle of twist when the 1 mm gap is open 

b)  Calculate the shear stress and angle of twist when the gap is closed by welding.

1847_open square tube.png

Posted Date: 3/11/2013 12:54:47 AM | Location : United States







Related Discussions:- calculate the shear stress and angle-open square tube, Assignment Help, Ask Question on calculate the shear stress and angle-open square tube, Get Answer, Expert's Help, calculate the shear stress and angle-open square tube Discussions

Write discussion on calculate the shear stress and angle-open square tube
Your posts are moderated
Related Questions
Tolerance Analysis This discusses the importance of assigning tolerances to the dimensions. Tolerance analysis is the process of assigning suitable tolerances. Proper assignme

we perform mockup test to 10 tube with tubesheet. please give the cutting plan?

Represent moment Graphically: How you represent moment Graphically? Sol.: Consider force F which is represented in magnitude and direction, by   line AB . L

Kelvi n Plank Statement: Sol: It is impossible to construct this type of H.E. that operates on cyclic process and converts all the heat supplied to it into equivalent

Calculate Size of Blank Required for Drawing A flanged cup shown in Figure is to be produced by deep drawing. Calculate the size of the blank required for drawing.

Q. Insulation for personnel protection? Insulation for personnel protection shall be provided as follows on all piping and equipment adjacent to work platforms or other operati

an arrangement of the wilson epicyclic gearbox giving four forward and one reverse speed of shaft D for an input speed of shaft E is shown in fig .3.in 1st gear Ii is fixed.in 2 ge

Resultant of coplanar concurrent force system: The resultant force, of given system of forces can be found out by the resolution method, which is discussed below: Assume th

Necessity of Electrical System Lights and horn for safe riding of vehicle even at night. Electricity for ignition of fuel in the engine. Battery Charging.

Q. Corrosion resistance of tantalum? Tantalum is readily attacked by strong alkalis, even at room temperature, and therefore, is not suitable for use in processes where the pH