Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In determining the difference in elevation between points A and B, the inclined distance was measured to be 157.65 ft.
The transit was setup on point A. The height of its transverse axis was 5.2 ft above point A
The instrument had an index error of +4’.
A rod was held on point B and the telescope is inclined so that the horizontal cross line of the transit intersects the rod at the 5.2 ft mark.
If the reading on the vertical limb of the transit was +25° 19’, what was the difference in elevation between the two points ?
Suppose you are told that a process must achieve a 2.7 log removal of Giardia cysts. What does that mean in terms of % remaining and % removal?
Tank A has a volume of 100 liters and contains saturated vapor r-134 at 30C. With the valve open slightly flow enters cylinder B. a pressure of 200kpa is required to lift piston in b. the process ends when the pressue at A drops to 200kPa.
A horizontal circular plate weighing 60-lb is suspended from three wires that are attached to a support at D and form 30 degree angles with the vertical. Determine the tension in each wire.
A 2:1 natural slope is underlain by a 3-m thick (measured vertically) soil cover over bedrock. Compute the factor of safety by using an effective stress infinite slope analysis with c'=0 and o' (theres a line between that)= 35 degrees for the soil..
After moving the bubble four divisions off center, the reading is 1.410 m. For 2-mm vial divisions, what is (a) the vial radius of curvature in meters and (b) the angle in seconds subtended by one division
An earthen channel will be excavated into sandy soil for which Vmax = 4.0 ft/sec, n=0.022 and the recommended m=3. The channel will have a bottom slope of 0.0011 and accommodate a design flow of 303 cfs. Design (size) the channel section.
1. draw a plan of a typical strip mine showing all operational features and equipment.2. answer the followinga. why is
hydraulic conductivity of soil is .009cm/sec at room tmeperature of 28*C. what would be the coefficient of permeability at 20*C
Sometimes the side of concrete bridges is observed to turn black in colour. What is the reason for this phenomenon? In prestressing work, if more than one wire or strand is included in the same duct, why should all wires/strands be stressed at the sa..
For a given load increment, the time for 50% consolidation was 5 min 20 sec. How long will it take for 50 % consolidation of a similar clay layer in the field that is 8.2 ft thick & drained on one side only
A hospital waste containing 0.7µCi/L of 32P is to be disposed of. How long must the radioisotope be held to meet the allowable discharge activity
A paved parking lot section has a uniform slope over a length of 100 m (in the flow direction) from the point of a drainage area divide to the inlet grate, which extends across the lot width of 30 m.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd