What is the first order decay coefficient in day-1

Assignment Help Civil Engineering
Reference no: EM13317892

A tank operated as a CFSTR used to remove benzene from a flow stream is 1500 m3 in size. The flow rate in and out of the tank is 8 m3/day. If the influent benzene concentration of 265 ug/L and the effluent concentration is 12 ug/L, what is the first order decay coefficient in day-1.

Reference no: EM13317892

Questions Cloud

Determine point of application from the base of wall : he top of the soil is level with the top of the wall, and the soil carries a uniformly distributed load of 500 psf. Calculate the total active earth force of the wall per linear foot and determine its point of application
Determine the waters speed in the wider pipe : Water flowing in a horizontal pipe is at a pressure of 1.55 105 Pa at a point where its cross-sectional area is 6.00 m2. Find the water's speed in the wider pipe
Estimate cross sectional dimension of bar under strain : A 1000 in diameter solid steel (p= 0.303) bar is 10.0 ft long. Under a tensile load. (a) Estimate the lateral strain experienced by the bar (b) Estimate the cross sectional dimension of the bar when under strain
Estimate the net outward force on a passengers eardrum : An airplane takes off at sea level and climbs to a height of 480 m. Estimate the net outward force on a passenger's eardrum assuming the density of air is approximately constant
What is the first order decay coefficient in day-1 : A tank operated as a CFSTR used to remove benzene from a flow stream is 1500 m3 in size. The flow rate in and out of the tank is 8 m3/day. If the influent benzene concentration of 265 ug/L and the effluent concentration is 12 ug/L
Prepare the cad drawings : Need to prepare the CAD drawings
How much work is done by the tension in the cable : A rescue helicopter lifts a 60 kg person straight up by means of a cable. The person has an upward acceleration of 0.70 m/s2, How much work is done by the tension in the cable
Determine what is the volume of the lake in cubic feet : Nitrification, the conversion of ammonia to nitrate (NH3 -> NO3-) occurs in the lake according to first - order kinetics. One stream feeds the lake and one stream empties the lake with the flow rate in both being 8 cfs
What is the flow speed in the narrower section : An ideal fluid flows at 12 m/s in a horizontal pipe. If the pipe narrows to half its original radius, what is the flow speed in the narrower section

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the efficiency of an esp required to meet federal

Assume that 30% of the ash falls out as bottom ash in the furnace. Calculate the efficiency of an ESP (electrostatic precipitator) required to meet federal new source performance standards

  Determine what percent removal efficiency may be expected

The current removal efficiency is 96% for an air flow rate through the separator equal to 18 m3/s. Due to a process change, the air flow rate is expected to increase to 22 m3/s.

  Determine smallest values of c and k for static deflection

the turbopump unit in the engine nominally operates at 7000 rpm, and a result of design issue, the actual thrust provided by the engine oscillates harmonically with an amplitude of 10 KN at the same rotational frequency as the turbopump unit.

  What is the design flow capacity for tailwater of tw

Two box culverts each is 0.61 m by 0.61 m and has n = 0.013, Ke = 0.05, Cd = 0.85, L = 30 m, So = 0.7%, and HW = 1.5 m. a. What is the design flow capacity for free outlet condition b. What is the design flow capacity for tailwater of TW = 1 m

  Load that a boat can carry without sinking in a lake

The hull of a boat has a volme of 150m and the total mass of the boat when empty is 8560kg. determine how much load this boat can carry without sinking in a lake.

  Calculate the heat and work excahnged during the process

a piston-and-cylinder device contains 5 kg of water initially at 150 C and 0.20 MPa. The frictionless piston is then pushed slowly in an isothermal process until the volume of water becomes 10% of its initial value.

  Calculate the stress at failure of a concrete test cylinder

Calculate the stress at failure of a concrete test cylinder with a measured diameter of 152.4 mm and a recorded load of 371,426N. Units of ksi.

  Determine what diameter should the spherical balloon have

A balloon is to be used to carry meteorological instruments to an elevation of 15,000 ft where the air pressure is 8.1 psia. The balloon is to be filled with helium, and the material from which it is to be fabricated weighs 0.01 lbf/ft^2.

  Find the solution of the ivp by solving the de

After the Christmas break one student returns carrying a flu virus. Assume that the rate at which the virus spreads is proportional to the number of infected students P(t), but also to the number 5000P(t) of students not yet infected.

  Determine the rise in water level within the drainage layer

A rectangular landfill in the New England area is 175 m in width, and sloped at the uniform angle of 75 degrees. Its cover system includes a drainage layer constructed of clean, medium sand (Ks = 10^-2 cm/s).

  Disposal of excavated material

Discuss and use examples to explain the specific factors that you will need to consider when pricing the following items in the bill of quantities foundation excavation

  Find the total mass

A container of volume 0.04 m3 contains a mixture of saturated water and saturated steam at a temperature of 250oC. The mass of the liquid present is 9 kg. Find the total mass, quality of steam, specific volume, specific enthalpy, and specific inte..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd