User Account

All Pages

What are the mole fractions of the liquid phase

Assignment Help Mechanical Engineering
Reference no: EM13711891

A vapor composed of 0.90 mole fraction ethanol and 0.10 mole fraction acetic acid at 120.0 mmHg (absolute), is in equilibrium with a liquid phase also composed of ethanol and acetic acid. Assume that the liquid is an ideal solution and apply Raoult\'s law to find the following.

1) What is the temperature of the liquid?

2) What are the mole fractions of the liquid phase?

Reference no: EM13711891

Questions Cloud

Solar water heater operating at steady state heats water : A solar water heater operating at steady state heats water from 90F to 120F. The panel is 3600 Btu/hr. Determine 1) the mass flow rate of the water in lb/min and 2) the volume of 120F water after 1 hour in gallons.
The stagnation temperature and stagnation pressure : Air flows at the rate of 1kg/s through a convergent-divergent nozzle. The entrance area is 2x10^-3 m^2 and the inlet temperature and pressure are 438 K and 580 kPa. If the exit pressure is 140 kPa and the expansion is isentropic, find;
Find the overall angular magnification of the microscope : The focal length of the eyepiece of a certain microscope is 18.0mm. The focal length of the objective is 8.00mm. find the overall angular magnification of the microscope
Estimate at what angle should the cannon be fired : A cannon with a muzzle speed of 992 m/s is used to start an avalanche on a mountain slope. At what angle, above the horizontal, should the cannon be fired
What are the mole fractions of the liquid phase : A vapor composed of 0.90 mole fraction ethanol and 0.10 mole fraction acetic acid at 120.0 mmHg (absolute), is in equilibrium with a liquid phase also composed of ethanol and acetic acid.
Soil with an convective heat transfer coefficient : A 30-cm-OD pipe with a surface temperature of 90 degrees C carries steam over a distance of 100 m. The pipe is buried with its centerline at a depth of 1 m, the ground surface temperature is at -6 degrees C, and the mean thermal conductivity of the s..
How far does it move : In a grocery store, you push a 12.3-kg shopping cart with a force of 12.2 N. If the cart starts at rest, How far does it move in 2.40 seconds
Provide strategies for working effectively in virtual teams : Review the Unit Introduction and the Learning Resources - Support your Individual Assignment with current academic literature beyond your Learning Resources.
Find the magnitude of the force that the bullet exerts : A 1.5g bullets is fired through a 28.0kg block traveling horizontally toward the bullet. Find the magnitude of the force that the bullet exerts

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Block of copper at initial temperature

A 25-kg block of copper at initial temperature of 1500C equilibrates with 0.79 kg of liquid water at an initial temperature of 200C in an insulated tank. If the average specific heat of copper can be taken to be 0.395 kJ/kg.K, determine the final tem..

  How long should the roughing section be what pull must the

a roughing section of a broach is to remove stock 3.2 mm deep from a steel surface205 mm long x 50 mm wide each tooth

  The currently used material is brass but you have decided

you are asked to design a solid circular shaft of minimum cost that is 1.3 m long and has to twist less than 3 degrees

  An ideal gas at 20 bar and 400 celcius is being fed into an

an ideal gas at 20 bar and 400 celcius is being fed into an adiabatic turbine to generate electricity at a rate of 278

  To what pressure in atm should the air in the wind tunnel

a model of an airplane is to be tested at 20degc in a wind tunnel. the model is built to 112th scale. in order to match

  A cylindrical torsion bar is made by bonding a solid bar

A cylindrical torsion bar is made by bonding a solid bar made of material 1 inside a tube made of material 2, as shown below. The yield stresses of the two materials are known as tauy1 and tauy2. Both materials have the same shear modulus, G, a..

  A 40 a current is set up in a circuit for 70 min by a

a 4.0 a current is set up in a circuit for 7.0 min by a rechargeable battery with a 3.0 v emf. by how much is the

  A blower develops 750mm of water gauge at a speed of

a blower develops 750mm of water gauge at a speed of 1480rpm and a flow rate of 38cubicmeter per sec. determine the

  Oil with a specific gravity of 070 is used as the

oil with a specific gravity of 0.70 is used as the indicating fluid in a manometer. if the differential pressure across

  Design a cooling system for this device as an emergency

an emergency situation developed as a result of the failure of the cooling system of a portable electronic device used

  Hydrogen flows through a horizontal insulated duct

Hydrogen flows through a horizontal insulated duct. At section1 the enthalpy is 2400 btu/lbm, the density is .5 lbm/ft^3 and the velocity is 500 ft/sec. at at downstream section, h2= 2240 btu/lbm and density2= .1 lbm/ft^3. No shaft work is done. Dete..

  Te local acceleration of gravity is 981 ms2 determine the

a gas is contained in a vertical frictionless pixton-cylinder. the piston m 10 kg a- 7.5 x 10-3 m2 is attached to a

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd