+1-415-670-9189
info@expertsmind.com
Verify the law for parallelogram of forces
Course:- Mechanical Engineering
Reference No.:- EM13314




Assignment Help
Expertsmind Rated 4.9 / 5 based on 47215 reviews.
Review Site
Assignment Help >> Mechanical Engineering

Explain the different experiment.

Purpose of this Practical is to verify the law for parallelogram of forces, law for triangle of forces and law of polygon of forces.

Purpose of this experiment is to test that three non-parallel forces in equilibrium can be represented by a triangle of forces.

When two forces act on a body in one plane in two different directions, they are equivalent to a single force. This equivalent force is called Resultant of those two forces.

The purpose of this experiment was to test that when four or more forces are in equilibrium at a point, they can be represented by a polygon of forces, from which unknown can be found.




Put your comment
 
Minimize


Ask Question & Get Answers from Experts
Browse some more (Mechanical Engineering) Materials
What is going on here? Is it likely that the customer could see so many bad assemblies, given what the manufacturer observed in its process? Perform appropriate calculations
The initial cost of a pickup truck is $10,478 and will have a salvage value of $3,959 after five years. Maintenance is estimated to be a uniform gradient amount of $142 per ye
Find the input angles corresponding to the toggle positions of the non-Grashof linkages in Table P4-1. (For this problem, ignore the values of θ2 given in the table.)
A reaction is found to be 25 times faster at 400 K than at 300 K. Measurements of the temperature exponent yielded a value of 0.7. Calculate the activation energy of the rea
A stream consisting of two organic chemicals: 1) Benzene (C6H6) and 2) Toluene (C7H8), enters a separation column. The total mass flow rate of the stream is 10,000 lbm/hr (pou
The flow around a model of a turbine blade is investigated. The model is five times larger than the prototype. A maximum pressure of 4 psi is measured at the leading edge, a m
In a cold air-standard Brayton cycle, air enters a compressor operating at steady state at 15 lb/in2, 80 degress F, with a volumetric flow rate of 6000 ft3/min. The compressio
Design a heat sink that will dissipate as much heat as possible - if it is assumed that the base plate is kept at a constant temperature of 380K - Advantages and disadvantag