+1-415-670-9189
info@expertsmind.com
Determine the source and sink temperature
Course:- Civil Engineering
Reference No.:- EM13317682





Expertsmind Rated 4.9 / 5 based on 47215 reviews.
Review Site
Assignment Help >> Civil Engineering

Carnot engine working between a source temperature of T2 and sink temperature of T1 has efficiency of 25%. if the sink temperature is reduced by 20 degrees Celsius the efficiency is increased to 30%. find the source and sink temperature




Put your comment
 
Minimize


Ask Question & Get Answers from Experts
Browse some more (Civil Engineering) Materials
Air enters an adiabatic nozzle steadily at 300 kPa, 200 o C, and 30 m/s and leaves at 100 kPa and 180 m/s. The inlet area of the nozzle is 80 cm 2 . Determine (a) the mass flo
The Pelton wheel is 3.0 m in diameter, and the nozzle exit is 0.2 m in diameter. Determine the maximum power output of the Pelton wheel. Is a Pelton wheel the appropriate tu
Draw and explain a pump curve that illustrates the effect of throttling in the CLOSED direction (i.e., reducing flow) the discharge valve for a constant speed centrifugal pump
Sketch the SCS triangular and curvilinear UHs and the mass curve for a 100-mi^2 watershed which is 60% good condition meadow and 40% good cover forest land. The watershed co
With a probable maximum allowable foundation pressure of 2000 psf, if column loads of a new building will be approximately 63,000lbs. How wide will a square spread footing n
A water treatment plant has 6 settling tanks that operate in parallel (the flow gets split into six equal flow streams), and each tank has a volume of 600 m3. If the flow to t
The azimuth from station A of a link traverse to an azimuth mark is 212o 12' 36". The azimuth from the last station of the traverse to an azimuth mark is 192o 12' 15". Angles
For the air system in the previous problem, find the increase in the air exergy from the inlet to the point of use. How much exergy was lost in the flow after the compressor