Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.Determine the elastic and plastic section modulus of the I-beam. The axis runs through the center of the beam on both x and y axis (completely symmetrical). Beam properties: h= 12inches tf= 0.5 inches bf= 6 inches tw= 0.25 inches
2.A hot air balloon starting on the ground ascends at a rate of 12 km/hr and is carried by the wind (horizontally) at a rate of 20 kn/h. When the balloon reaches a height of 50 m, a ballast bag is dropped. Where does the ballast bag land relative to the starting location of the balloon? What is the speed of the ballast bag when it lands?
A cone penetration test has been conducted and has measured a con resistance of 85 kg/cm^3 at a depth of 10m. the vertical effective stress at this depth is 159KPa and the over consolidation ratio is 2
An activated sludge process receives 4000m^3 / day containing 120 mg BOD /L from the primary settling tank and 3500 m^3/day Containing 25mg BOD/L from the secondary settling tank.
Consider an electric field that is uniform in direction throughout a certain volume. can it be uniform in magnitude?
A polystyrene rod consisting of two cylindrical portions AB and BC is restrained at both ends and supports two 6-kip loads as shown. Knowing that E = 0.45 X 106 psi, determine (a) the reactions at A and C, (b) the normal stress in each portion of the..
Using the following assumptions, determine the solids retention time, the cell wastage flow rate, and the return sludge flow ratefor the Jambalaya shrimp processing plant WWTP
The pollutant has a reaction rate coeeficient k of 0.25/day. Assuming is pollutant is well mixed in the lake, find the steady-state concentration of pollutant in the lake.
For satisfactory operation, the static pressure at the pump inlet must not be lower than -6 m of water gage. Determine the smallest standard commercial pipe that will give the required performance.
Earth whose in situ weight is 110 lb per cf and compacted weight is 124 lb per cf is placed ina a fill at rate of 280 cy per hr, measured as compacted earth. The thickness of the compacted layers is 8 in.
Three solid shafts, each of 3/4 in. diameter, are connected by the gears shown. Knowing that G=11.2*10^6 psi, determine (a) the angle through which end A of shaft AB rotates, (b) the angle through which end E of shaft EF rotates.
A water treatment plant is being designed for a flow of 1.6 m^3/s. How many rapid sand filters, using only sand as the medium, are needed for this plant if cross-sectional area of each filter is 10 m x 20 m
A 20-kg iron ball is moving at 100 km/hr should be accelerated at a constant rate of 10 m/(sec)^2. What is the force required
At point 2, the velocity and pressure are 14 ft/s and 23 psi. Determine at which of these two points the elevation is higher. Calculate the height difference. (Assume the sp ecific gravity of butane is 0.6 and that the butane is at a temperature o..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd