Determine its thermal conductivity k between two surfaces

Assignment Help Civil Engineering
Reference no: EM13300391

Two surfaces of a 2cm thick plate are maintained at 0*C and 80*C, respectively. Heat is transferred through the wall at a rate of 600 W/m^2., determine its thermal conductivity,k.

Reference no: EM13300391

Questions Cloud

Explain the angular momentum quantum number determine : What does the angular momentum quantum number determine. Check all that apply. A.) the overall size of an orbital B.) the energy of the electron on the outer shell
Determine corrosponding pressure exerted by the brass ring : a brass ring of 120-mm outside diameter is fits exactly inside a steel ring of 120-mm inside diameter when the temperature of both rings is 5 degrees C. knowing that the temperature of the rings is then raised to 55 degrees C
Calculate the magnitude of the magnetic force on the proton : A proton moves at a speed of 995 m/s in a direction perpendicular to a magnetic field with a magnitude of 0.76 T
How much value will this investment create for the firm : How much value will this investment create for the firm and at what discount rate will this project break even?
Determine its thermal conductivity k between two surfaces : Two surfaces of a 2cm thick plate are maintained at 0*C and 80*C, respectively. Heat is transferred through the wall at a rate of 600 W/m^2., determine its thermal conductivity,k.
Architectural motifs reinterpreted in medieval art : How are Roman art and architectural motifs reinterpreted in medieval art? Give at least 3 specific examples that you explain.
Explain many moles of magnesium oxide are produced : How many moles of magnesium oxide are produced by the reaction of 3.82 g of magnesium nitride with 7.73 g of water? Mg_3N_2 + 3H_2O yields 2NH_3 + 3MgO
A dice is thrown thrice : A dice is thrown thrice. What is the probability that the largest score that turns up is three times the smallest?
Draw thermal circuit of heat flow from center of pipe to t : Steam at 100 psia, sat vapor is in a pipe. The pipe is schedule 40 steel with a wall thickness of 1/8 inch and a length of 100 ft. The outside air temperature is 40 degrees Fahrenheit. The mass flow of steam is 4,000 lb/hr.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What should be the surface area of the lagoon

If the evaporation rate from an open water surface is 0.27 inch/day in Tucson Arizona, what should be the surface area of the lagoon? (Note: arsenic does not evaporate but remains in the liquid water)

  Horizontal axle passing through center

A 75g , 30cm--long rod hangs vertically on a frictionless, horizontal axle passing through its center. A 12g ball of clay traveling horizontally at 2.5m/s hits and sticks to the very bottom tip of the rod.

  Mass of water vapor diffuses through tube

If the water vapor is removed from the upper tank so that the concentration there remains nearly zero, what mass of water vapor diffuses through the tube each hour?

  Average shearing stress

Two strips of a plastics material are bonded together as shown. The average shearing stress in the glue must be limited to 1000 kpa.

  Determine time required for the bed to complete a full cycle

The velocity of the bed is limited to a maximum value of 150mm/s to the right and 300mm/s to the left; the acceleration is successively equal to 150mm/s^2 to the right, zero 150 mm/s^2 to the left, zero, etc.

  What is the astronomic azimuth of the line

The magnetic north azimuth of a line is 128 degrees 27' while the magnetic declination is 3 degrees 30'E. What is the astronomic azimuth of the line (in decimal degrees)?

  What is the new water content

A soil sample with a water content of 14.5% and unit weight of 128.2 lb/cu. ft. was dried to a unit weight of 118.8 lb/cu. ft. without changing its void ratio. What is its new water content (in %)?

  Find estimated primary consolidation settlement of structure

A compressible clay layer 10.0m thick has an initial void ratio in situ of 1.026. Tests and computations show that the final void ratio of the clay layer after construction of a structure is 0.978. Determine the estimated primary consolidation set..

  Determine what is power developed with an overall efficiency

A turbine discharges water at 0.4 m3/s under a head of 10.50 m and with an overall efficiency of 80 %. determine what is The power developed.

  How much larger should street name be in order to be legible

street nam sizes on the signs at a certain location can be discerned by a person with 20/40 vision from a distance of 300 ft. how much larger should the street names be in order to be legible to a person with 20/50 vision from a distnace of 450 ..

  What is its depth in the 18 inch diamenter pipeline

Sewage flows through a 12" diameter pipeline then through an 18" diamenter pipeline. The flow is the same (unknown) value in each pipe, and the slope is the same (unknown) contant value for both pipes.

  Explain what offers no restraint to motion in the y-z plane

The cable is taut and prevents motion of point B in the x-z plane (i.e. acts as a pin for y-axis buckling), but offers no restraint to motion in the y-z plane (i.e. is unsupported for x-axis buckling).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd