Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Design a voltage-divider bias network using a supply of 24V, a transistor with a Beta of 110, and an operating point of IC = 4mA, and VCE = 8V. R2 = 7.5k. Choose VE = (1/8)VCC
It is given that the energy consumed by a computer system is (100 Joules/sec^2)*t^2 Joules during the first second after being activated at t=0. What is the average power dissipation during this time
A rectangular chip has a top surface of 0.5 cm by 2 cm cooled by air at 20 oC with h = 150 W/m2.K. There are also 16 connector pins, 1 mm wide, 0.5 mm thick, 6 mm long and k = 60 W/m.K attached to a circuit board at 30 oC.
The input impedance of a JFET used in COMMON SOURCE configuration, is defined by two considerations: The JFET itself has a VERY HIGH INPUT IMPEDANCE, because the input is the GATE to SOURCE junction that is REVERSE biased
The transformer secondary is now connected to a purely resistive load drawing 50A. Calculate: a) the total resistance and leakage reactance values referred to the secondary (Rt2 and Xt2), b) the output voltage, c) the output power, VA and Vars,
In a power supply, a 150 microfarad capacitor was connected in parallel with a 200 kOhm resistor. The capacitor was maintained at a charge level of 350 volts DC. After power was removed for ten seconds, someone god a shock from touching the termin..
An 8-kg plunger is released from rest in the position and is stopped by two nested springs; the constant of the outer spring is k1 = 4 kN/m and the constant of the inner spring is k2 = 12 kN/m. If the plunger is released from the height
The upper and lower conducting plates of a large parallel-plate capacitor are separated by a distanced and maintained at potentials V0 and 0, respectively. A dielectric slab of dielectric constant 6.0
1) What is the difference between a continuous spectrum and a line spectrum 2) What is the fundamental difference between a continuous signal and a discrete signal 3) Why are linear time invariant (LTI) systems so important in engineering and enginee..
A pn junction diode is forward biased by a Thevenin circuit consisting of Rth = 5kohm and Vth = 10sinwt where w= 2pi*10rads/s. Find the diode voltage and current as functions of time.
A platinum resistance coil has a resistance at O0 C of 100 . Determine the change in resistance that will occur when the temperature rises to 30°C if the temperature coefficient of resistance is 0.0039 K-1.
An amplifier has an open-circuit voltage gain of 100. With a 10-KOhm load connected, the voltage gain is found to be only 80. Find the output resistance of the amplifier.
A candidate material for a turbine blade application oxidizes by diffusion of metal atoms through the oxide to the metal surface, where metal and oxygen react to form the oxide. After 10 hours at 550*C, an oxide layer 8µm thick has formed.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd