Consolidation of the clay layer

Assignment Help Civil Engineering
Reference no: EM13866247

Task 1

2-For case the study shown in figure below, explain how the consolidation process could be expected due to the consolidation of the clay layer, and estimate the period over which this will take place.

2-Referring,again,to case the study shown in figure below, explain how the consolidation process could be accelerate so that the construction of the road pavement could be carried out after a 6 month period of the embankment being build, if the maximum permitted settlement after the construction of the road pavement was 25 mm . you explanation mus be supported by appropriate calculation.

413_consolidation process.jpg

Reference no: EM13866247

Questions Cloud

Brake power and indicated power of a petrol engine : The difference between the brake power and indicated power of a petrol engine and a diesel engine
Knowledge of shear strength : Select examples of civil engineering works where knowledge of shear strength is required and use these to explain the significance of the drained and undrained tests.
A schedule showing the depreciation : The Lord Company purchased a machine on January 2, 2010, for $70,000. The machine had an expected residual value of $10,000, an expected life of eight years or 24,000 hours, and a capacity to produce 100,000 units. During 2010, the company produced 1..
What are the advantages a of integers and floating numbers? : What are the advantages and disadvantage of integers and floating numbers?
Consolidation of the clay layer : For case the study shown in figure below, explain how the consolidation process could be expected due to the consolidation of the clay layer, and estimate the period over which this will take place.
Essay about embryonic stem cell research : Write an essay about Embryonic stem cell research and my part is about why research should be increased
Describe what the law requires with respect to the legal : Describe what the law requires with respect to the legal ruling in Credit Alliance v. Arthur Andersen & Co Do you think the ruling establishes a fair basis for an auditor legal liability to third parties?
The following costs relate to the acquisition and use of the : The Heist Company purchased a machine on January 2, 2010 and uses the 150% declining balance depreciation method.
A basis for an auditor legal liability to third parties? : How does each concept establish a basis for an auditor legal liability to third parties?

Reviews

Write a Review

Civil Engineering Questions & Answers

  How much time will it take for chemical to reach concention

Chemical ‘x' is regulated by EPA and the maximum allowable concentration in water is 10g/L. 1000 kg of chemical ‘x' is released in a lake (volume 1,000 m3) where it undergoes degradation as a first order reaction process

  What is the elevation for station

Station 0+00 is at BM which has an elevation of 508.97. During the survey, the backsight (BS) to this monument is recorded as 10.92. The level is then turned to sta 1+48, and the foresight (FS) is recorded as 13.14. Next the level is moved to a new p..

  Determine the diameter of commercial steel pipe required

Determine the diameter of commercial steel pipe required to convey a minimum of 300 cfs of water at 60 deg F with a head loss of 1.2 ft per 1000 ft of pipe. Assume pipes are available in the following nominal diameters (inches)

  How much extra water does concrete can displace

How much extra water does a 21.5 ft, 175-lb concrete can one displace compared to an ultra-lightweight 38-lb Kevlar canoe of the same size carrying the same load

  What volume of ambient air was compressed

When the ambient air is at 70 degrees Fahreneit, 14.7 psia, and contains 21% oxygen by volume, 4.5 lb of air are pumped into a scuba tank, capacity 0.75 ft^3. What volume of ambient air was compressed?

  The dynamic magnification of response compared

Detennine (1) the required shaker frequency to cause "resonance" and (2) the dynamic magnification ofresponse compared with static response for that level of damping.

  Determine critical crack length to assure plate wont fail

A 1047 steel plate is subjected to a tensile stress of 120 MPa. Given its fracture toughness is 45 MPa?m and Y = 1, (a) Determine the critical crack length to assure the plate will not fail under static loading.

  Find the probability that temperature exceeds 58 degree f

The following data are the temperatures (in °F) of effluent at discharge from a sewage treatment facility on consecutive days: 43 47 51 48 52 50 46 49 45 52 46 51 44 49 46 51 59 45 44 50 48 50 49 50

  What should be the surface area of the lagoon

If the evaporation rate from an open water surface is 0.27 inch/day in Tucson Arizona, what should be the surface area of the lagoon? (Note: arsenic does not evaporate but remains in the liquid water)

  Determine the thickness of the laminar sublayer

For the fully developed flow of water in a smooth 0.15-m pipe at a rate of 0:006m3/s, determine the thickness of a. the laminar sublayer; b. the buffer layer; c. the turbulent core

  Is the plant in violation of the deq discharge limit

Immediately upstream of the treatment plant, the Pine River has an ultimate CBOD of 2 mg/L and a flow of 9 × 105 m3/day. At a distance of 20 km downstream of the treatment plant, the Pine River has an ultimate CBOD of 10 mg/L.

  What will be the discharge at a depth of 50cm in the pipe

A concrete sewer pipe 1m in diameter is laid so it has a drop in elevation of 30cm per 300m of length. If sewage (assume the properties are the same as those of water) flows at a depth of 50cm in the pipe,

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd