Calculate the work done on the lead shot

Assignment Help Physics
Reference no: EM13312554

After inverting the tube 100 times, the temperature of the lead shot is found to have increased by 30C. Calculate the work done on the lead shot.

Reference no: EM13312554

Questions Cloud

Design cylindrical composite column consisting of steel rods : design a cylindrical composite column consisting of some steel rods, and also wrapped in nano-fiber material. The column must support a compressive axial force of 500 kips. The columns length is 5 ft.
Explain the concentration of the molar increase : How will the molar mass of an unknown acid be affected if some of the solid remained after the titration was complete. Will the concentration of the molar increase, decrease, or have no effect
Determine the strategic opportunity for global marketing : Actual brand value depends on the calibration of the 4Ps within a particular market. Price comparisons among competing brands in a designated foreign country market determine the strategic opportunity for global marketing
What is the internal resistance of the battery : A 6.00 V lantern battery is connected to a 10.5 (ohm) lightbulb, What is the internal resistance of the battery
Calculate the work done on the lead shot : After inverting the tube 100 times, the temperature of the lead shot is found to have increased by 30C
Estimate the moisture content and moist density : A 0.4m^3 moist soil sample has the following: Moist mass = 711.2 kg, Dry mass 623.9 kg, Specific gravity of soil solids = 2.68 Estimate: a). Moisture content. b). Moist density.
Explain total ion concentration : If 0.015 M NaCl shows conductivity of 12,000 units, based on "total ion concentration" what conductivity should be observed for 0.015 M K2SO4
What is the speed of the wind : A small airplane flies with a speed relative to the ground (ground speed) of 212.0 km/h in a direction 19.0 degrees to the east of north. what is the speed of the wind
Capstone project : Capstone Project

Reviews

Write a Review

Physics Questions & Answers

  Estimate the total energy of the oscillating system

A 2.5kg mass is attached to a spring and placed on the horizontal, smooth surface. A horizontal force of 18.4 N is necessary to hold the mass at rest while it is pulled 0.210 m from its equilibrium position.

  Determine the thermal conductivity of the styrofoam

A Styrofoam box has a surface area of 0.74 m2 and a wall thickness of 2.0 cm. The temperature of the inner surface is 5.0°C,  determine the thermal conductivity of the Styrofoam

  How far away did the shell hit

A ball is thrown upward at a speed v0 at an angle of 50.0° above the horizontal. It reaches a maximum height of 7.5 m. How high would this ball go if it were thrown straight upward at speed v0.

  What is the size of the frictional force acting on the car

What is the size of the frictional force acting on the car

  What is the initial angle of the cannonball

A cannonball is shot (from ground level) with an initial horizontal velocity of 40 m/s and an initial vertical velocity of 21 m/s, What is the initial angle of the cannonball with respect to the ground

  Calculate the mass of a cube

The density of ma ial at the center of a neutron star is approximately 1.00 x 10^18 kg/m^3. Calculate the mass of a cube

  Determine the impact location and the impact speed of puck

Consider a rocket-powered hockey puck, and assume the rocket produces a constant acceleration when the rocket is on. Determine the impact location and the impact speed of the puck

  Determine the thermal efficiency

A heat engine extracts 50.0kJ of heat from the hot reservoir each cycle and exhausts 35.0kJ of heat. What is the thermal efficiency

  Calculate the net resistance of the circuit

four resistors and a capacitor are connected to an 18 v battery with negligible internal resistance, calculate the net resistance of the circuit

  What is its initial velocity as it leaves the ground

Four or five gram blocks of metal are sitting out in the sun and absorb the same amount of heat energy. Use the following specific heat capacity data to resolve which block will increase its temperature the most.

  Determine the image distance for object from diverging lens

Determine the image distance for an object do=7.900 cm from a diverging lens of radius of curvature 6.320 cm and index of refraction 1.800.

  Determine the velocity when it hits the floor

An object with a mass of m = 4.6 kg is attached to the free end of a light string wrapped around a reel of radius R = 0.265 m, determine the velocity when it hits the floor

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd