Calculate the fluid velocities at the two ends

Assignment Help Civil Engineering
Reference no: EM13312140

Assume frictionless flow in a long, horizontal, conical pipe. The diameter is 12 inches at one end and 6 inches at the other. The pressure head at the smaller end is 16 feet of water. If water flows through this cone, from the larger to the smaller end, at a rate of 150 gallons per minute (gpm), calculate the fluid velocities at the two ends and the pressure head at the larger end.

Reference no: EM13312140

Questions Cloud

How many iron atoms are contained in the paper clip : A typical paper clip weighs 0.59 gram and consists of BCC Iron. The density of iron is 7.87 gram/cm3 and its atomic radius is 0.124 nm. What is the volume of a unit cell in (nm)3. What is the volume of a unit cell in cm3.
How to calculate ka for the unknown weak acid : When 2.45g of an unknown weak acid (HA) with a molar mass of 85.0 g/mol is dissolved in 250.0 g of water, the freezing point of the resulting solution is -0.255 C. Calculate Ka for the unknown weak acid.
Explain pump curve that illustrates the effect of throttling : Draw and explain a pump curve that illustrates the effect of throttling in the CLOSED direction (i.e., reducing flow) the discharge valve for a constant speed centrifugal pump installed in a cooling water system.
Describe a modification to the random port scan : Describe a modification to the random port scan, as describe in previous exercise, so that it still use a randomly generated sequence of port numbers but will now have exactly the same number of attempted TCP connections as a sequential port scan.
Calculate the fluid velocities at the two ends : Assume frictionless flow in a long, horizontal, conical pipe. The diameter is 12 inches at one end and 6 inches at the other. The pressure head at the smaller end is 16 feet of water.
Explain the percent by mass of nitrogen in nh4no3 : Which expression represents the percent by mass of nitrogen in NH4NO3. A) 14 g N/80 g NH NO 100% B) 28 g N/80 g NH NO 100% C) 80 g NH NO /14 g N 100% D) 80 g NH NO /28 g N 100%
Create an master production schedule : Create an Master Production Schedule and a Material Requirement Planning Chart
How many feet of head must the pump add to achieve : At a pumped storage facility, water is pumped from a large reservoir to a point 150 feet above the resevoir. How many feet of head must the pump add to achieve 10,000 lbm/hr flow through a 24 inch pipe with a friction head loss of 1.5 feet
Find the velocity of the wood : A block of wood of mass 4.85 kg rests on a horizontal frictionless surface. find the velocity of the wood after the bullet has passed through

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the design speed of the curve

An equal tangent vertical curve connects a -2% and a +3% grade. The low point of the curve is at elevation 297.88 ft. If the PVI is at elevation 295 ft, what is the design speed of the curve

  Calculate the required diameter of steel tie rods

CALCULATE THE REQUIRED DIAMETER OF STEEL TIE RODS NECESSARY TO SUPPORT A BALCONY. EACH ROD, SUSPENDED FROM A ROOF TRUSS, SUPPORTS A FLOOR AREA OF 7.0m^2. THE COMBINED BALCONT FLOOR LOAD IS 10.5 kPa

  Determine the time required for the particle to come to rest

Given: acceration = -k*sqrt(v) and k is a cosntant when x=0, v=81 m/s, t=0 when x=18 m, v=436 m/s determine: a) velocity of particle when x=20 m b) the time required for the particle to come to rest

  Find the magnitude and direction of the friction force

Determine whether the block shown is in equilibrium and find the magnitude and direction of the friction force when theta=30 and P=150N

  What is the station of the pt on a single-lane highway

A Horizontal curve on a single-lane highway has its PC at station 123+70 and its PI at station 130+90. The curve has a super-elevation of 0.06 ft/ft and is designed for 70 mph. What is the station of the PT

  Calculate how many minutes it takes for the runner to run

A sprinter runs using a force of 200 N and a power output of 600 W. Calculate how many minutes it takes for the runner to run 1 km.

  Find what would be the minimum number of truckloads

Soil is excavated from a borrow to construct an embankment with a net volume of 50,000 cy with 95% of Modified Proctor maximum dry density of 110 pcf with a Modified Proctor optimum water content of 8%.

  Find what was the temperature t of water evaporated

After the copper mass is added, the final temperature of the mixture is 38 degrees Celsius. By checking the mass, it is determined that 1.2 grams of water evaporated. What was the temperature T

  What is the allowable minimum length of the ramp

Using the ADA code, what is the allowable minimum length of the ramp base if base if it is 2 ft high and the code is 1:12

  How to calculate the forces in members ec and ef

Using method of joints, calculate the forces in members EC and EF. Note that the length of the member CD is 3.464 m, the length of member EC is 2m, and angle CDE is 30 degree ( this will cut down a bit of trigonometry effort).

  Compute the station and elevation of the curve turning point

Set up a table showing curve elevations at the PVC, at the PVT, and at the half-station points along the curve. Compute the station and elevation of the curve turning point.

  What is the average specific gravity of solid constituents

a soil sample is obtained by pushing a 16 in long tube into the side of a pit. the tube has an inside diameter of 3 in. and weighs 1.8 lb. The soil in the tube is trimmed so that its ends are flush with the ends of the tube.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd