Calculate the diameter of this pipe

Assignment Help Civil Engineering
Reference no: EM13533440

1.A riveted steel pipe transports water 190-feet at2.4-ft3/sec with aheadloss of 2.7-feet. Calculate the diameter of this pipe.

2.Using the Hazen-Williams approach (seecoefficient table below), find the headloss of water flowingthrough 1,000-ft of 6-ft diameter concrete pipe at a flow rate (Q)of 80 ft3/sec

Reference no: EM13533440

Questions Cloud

Determine the corresponding height of capillary rise in soil : The void ratio of a given soil A is twice that of another soil B,while the effective size of particles of soil A is one-third thatof soil B. The height of capillary rise of water in soil A on acertain day is found to be 400 mm. Determine the correspo..
Calculate the pressure at the clay-sand interface for two : Calculate the pressure at the clay-sand interface for two cases:1) clay on top of the sand and 2) clay on the bottom of thevertical sand column.
What is the maximum torque the tube can transmit if the : A thin tube of 1/8 in thickness has a mean diameter of 6 in. What is the maximum torque the tube can transmit if the allowable normalstress in compression is 10 ksi?
Find the rate that the trucks line up : A container ship carries 2000 units. It must be unloaded andre-loaded in a 48 hr turnaround. Two cranes are available. Find the rate that the trucks line up, load and pass under each crane.
Calculate the diameter of this pipe : Using the Hazen-Williams approach (seecoefficient table below), find the headloss of water flowingthrough 1,000-ft of 6-ft diameter concrete pipe at a flow rate (Q)of 80 ft3/sec
What is the oil flowrate in stb : Two wells had been drilled on 40-acre spacing. Well 1 is injectionand Well 2 is producing well. Downhole injection pressure is 8500psi, and bottomhole pressure in producing well is 2400 psi.
How many passengers per day are carried : A bus line 4 miles long runs through an area with 1/6 acre lots,3.5 people per household, average 1 car per household. People willwalk up to 1/6 mile to a bus stop, so stops are located 1/3 mileapart along the route. Say commuters will tolerate 20 mi..
What is the demand for time if left turns are provided : Given the following geometry of an intersection: Four lanes fornorth and southbound traffic; two lanes for east and west boundtraffic. The peak hour volume for
What are the horizontal distances : The slope distances shown were measured with an EDM while the differences in elevation between the ends of each line were determined by leveling. What are the horizontal distances?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the minimum diameter a steel wire can have

If the elastic limit of steel is 5.0 10^8 Pa, determine the minimum diameter a steel wire can have if it is to support a 69-kg circus performer without its elastic limit being exceeded.

  Determine the time in seconds to obtain a density

The salt water mixes thoroughly with the fresh water and the mixture overflows out of the tank. If the flow rate out of the tank is 60 liters/minute. Assume freshwater is 1000 kg/m^3, and the salty water is 1020 kg/m^3.

  Evaluate the rates of linear and angular deformation

Consider the pressure-driven flow between stationary parallel plates separated by distance 2b. Coordinate y is measured from the channel centerline. The velocity field is given by u=u max(1-(y/b)^2).

  A town is installing a new 10 main to carry drinking water

a town is installing a new 10 main to carry drinking water. the onlynbspsection remaining to be installed is a segment

  Define mechanical engineering dynamics

Important information about Mechanical engineering dynamics, A 3000 lb car rests on a horizontal street out of gas with its brakes locked.

  Determine downstream depth necessary to form hydraulic jump

water flows at a velocity of 25 ft/s at a depth in a rectangular channel 16 feet wide. Determine the downstream depth necessary to form a hydraulic jump, the head loss through the jump and the horsepower dissipated in the jump.

  What is the diameter d of the smallest -size particles

in a hydrometer test , the results are as follows:Gs =2.60 , temperature of water=24c ,and R=43at 60 min after the start of sedimentation . what is the diameter , D, of the smallest -size particles

  Find the final speed

Two carts with masses of 4.72 kg and 2.84 kg move toward each other on a frictionless track with speeds of 4.86 m/s and 3.97 m/s respectively. The carts stick together after colliding head-on. Find the final speed.

  Define what are the quantitative measures of reliability

What are the quantitative measures of reliability (discuss measures for hardware, software, personnel, facilities, and data)?

  Find what combinations of loads produce the max shear

beam is fixed at one end, spans 21' then goes over a roller support then 6' continues to hang over. there is a point load halfway betwen the supports (10.5') and another at the far end. there is also a distributed load that stretches the entire be..

  How to use the bisection method on the van der waals

how to use the bisection method on the van der waals equation Problem 1 (15 Points) The van der Waals equation gives a relationship between the pressure P (in atm.), volume V (in L), and temperature T (in K) for a real gas

  Determine the minimum force p to prevent a 30kg rod

Determine the minimum force P to prevent a 30kg rod AB from sliding on a wall. The contact surface at B is smooth, whereas the coefficient of static friction between the rod and the wall at A is Us=0.2.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd