Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A watershed has four sub-areas. The annual precipitation and evaporation from each of the sub-areas are given in Table(below). Assume that there is no change in groundwater storage on an annual basis and calculate for the whole catchment the values of annual average (i) precipitation (ii) evaporation. What are the annual runoff coefficient (Runoff/Rainfall ratio) for the sub areas and for the total watershed taken as whole Sub-area Area (m2)/ Annual Precipitation (mm)/ Annual Evaporation (mm) A 10.7/ 1030/ 530 B 3.0/ 830/ 438 C 8.2/ 900 /430 D 17.0/ 1300/ 600
Determine the elastic and plastic section modulus of the I-beam. The axis runs through the center of the beam on both x and y axis (completely symmetrical). Beam properties: h= 12inches tf= 0.5 inches bf= 6 inches tw= 0.25 inches
At the end of year 1 the piece of equipment is worth $15,000 and at the end of year 2 $13,000, and at the end of the third and final year the salvage value is equal to $9,000.Applying the straight line depreciation, calculate the depreciation expe..
Determine, for the crest and sag vertical curves required, the stationing and elevation of the PVCs and PVTs given that the PVC of the crest curve(on westernmost level highway section) is at station 0+00 and elevation 100 ft.
A siphone generates a flow of 1 ft/sec thru a 1 inch OD, 3/4 ID hose. A) What height difference is needed to generate this flow B) What height for 10 ft/sec C) What for 100 ft/sec
A MIPS-based computer system with 2 GB of main memory that is built on a single circuit board. It is designed with a single control signal between the CPU chip and main memory, i.e. one bit of control that is set to one for Read operations
what is the engineering ethics case related to civil engineering with reference and discuss all the engineering ethics issues which covered the "Engineering etics concepte and cases?
A rectangular channel is 25ft wide and has a flow of 500 cfs at a velocity of 5ft/s. (a) Determine the specifc energy of water in the channel. (b) What is the criticl depth of water in the channel (c) What is the critical velocity
If the dry-rodded unit weight of an aggregate is 105 lb/ft3 (1680 kg/m3) and its specific gravity is 2.65, determine the void content.
The point of intersection of the tangents is located at station (948+67.32). If the design speed of the highway is 60mi/h, determine both the point of tangent and the deflection angles to whole stations for laying out the curve. Select appropriate..
If the time required to pay for parking is exponentially distributed with a mean of 15 seconds, find the average time in system.
If the column is subjected to an axial compressive force of 800 kN, determine the required diameter of each reinforcing steel bar so that one-third of the load is carried by the steel and two-thirds by the concrete. Assume Esteel= 200 GPa and Econ..
The pipe contains two 6 in steel elbows, two fully open gate valves, a fully open 90o angle valve, and a swing check valve. If the discharge end of the pipe is located 20 ft higher than the entrance, what is the pressure difference between the two..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd