Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 1.5 kW heater and a 5 hp induction motor are operated from a 208V, three-phase supply. The motor has a full load efficiency of 80% and a full load power factor of 0.85. What is the motor current and what is the total supply current?
Design a multiplexer which has four input lines, two controllines, and one output line and a demultiplexer which has one input line, two control lines, and four output lines using truth tables and k-maps.
Determine the signal/noise ratio (Eb/No) in input of the receiver for each modulation format presented below if symbol error rate (SER) is required to be 10-^4 (use the coherent detection), for the solution the appropriate graphs can be used inste..
define state variables, determine the required initial conditions, and use Matlab to solve for voltages Vc(t) and Vo(t). Plot the results, and verify that the numerical solution using state variables matches the hand calculation solution.
An MFSK modulation scheme with M = 4has a carrier frequency of 250 kHz, a difference frequency of 25 kHz, and two bits per signal element. Make a frequency assignment for each of the possible data combinations.
(a) Using the default power transistors, determine the minimum supply rail voltage required if TJ
Calculate: i. The A, B, C, D constants of the line. ii. The characteristic impedance of the line. iii. The sending-end voltage iv. The sending-end current. v. The sending-end power factor. vi. The sending-end power. vii. The power loss in the line..
At the beginning of each year, the cows are divided into three groups. Young heifers (aged 0 to 1 year) make up the first group. The second group consists of cows aged 1 to 2 years, and the third group consists of all cows aged 2 years or older.
Using Multisim, design a mod-100 BCD counter that drives a 2-digit, 7-segment display. The count sequence will be 0 through 99. Blank leading zeros in the tens digit of the display.
The measured current, voltage and power factor of a premium-efficient, three-phase, 125-hp air compressor motor are shown in the table below. Assume motor is 95.3% efficient at all loads. Loaded Unloaded Current (Amps) 127 63 Voltage (Volts) 476 47..
Explain the difference in amplitude associated with the output waveform based on the operation of the semiconductor diodes. background info: in the ouput the square wave oscillates from 0V to 1.1625V.
A differential equation of a system with x(t) as an input and y(t) as an output is defined as a.)Find the system response to unit step function, x(t)= u(t), where b.) Specify the Zero Input Response.
(a) Design a high-pass filter with a cutoff frequency of 40 kHz. Use 0.01 uF capacitor and an appropriate resistor. B) Sketch and label the circuit. C) What is the gain of the filter at the cutoff frequency Give your answer both as ratio (Vout/Vin..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd