Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In cooling situations where the desired temperature range is large, two refrigeration cycles can be stacked to create a cascading refrigeration system that increases the cooling capacity compared to a single-cycle system. A cascade system using two ideal refrigeration cycles is used. The high-temperature cycle uses Refrigerant-134a with saturated liquid leaving the condenser at 40C and saturated vapor leaving the heat exchanger at -20C. The low-temperature cycle uses Refrigerant-23, which is suitable for use in the colder temperature conditions. Refrigerant-23 leaves the evaporator as a saturated vapor at -80C with h = 330 kJ/kg, saturated liquid leaves the heat exchanger at -10C with h = 185 kJ/kg, and the fluid leaves the compressor with h = 405 kJ/kg.
a.) Determine the ratio of the mass flow rates for the two cycles.
b.) Determine the coefficient of performance for the overall system.
a cantilevered bar is 500 mm long with square cross section 25mm x 25 mm. three perpendicular forces are applied to its
If the atmospheric pressure is 90 kPa, determine the pressure inside the cylinder.
using excel find the value of the 95 confidence interval for a single-sample using the z variable and the students
the air supply to an engine is measured by being taken directly from the atmosphere into a large reservoir through a
An oven door consists of a layer of asbestos sandwiched between a layer of steel on the inner surface and a layer of wood on the outer face
how would you use a pulley system with one rope to pull at a single item at two points simultaneously?the free ropes of
a turning operation calls for a single pass on a 3 diameter part down to 2.800 on a lathe using a hss high speed steel
steam is contained in a rigid container at an initial pressure of 100 psia and 600 f. the pressure is reduced to 10
Air enters an adiabatic duct of L/D = 40 at V1 = 170 m/s and T1 = 300 K. The flow at the exit is choked. What is the average friction factor in the duct?
a device with an inlet cross-sectional area of 1 ft2 receives oxygen flowing at m0.2 with pt100 psia and tt1000 ordmr.
an ideal rankin cycle uses water as a working fluid which circulates at a rate of 80kgs. the boiler pressure is 6 mpa
the system shown starts from rest and each component moves with a constant acceleration. if the relative acceleration
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd