Rate of heat transfer between the steam and cooling water

Assignment Help Mechanical Engineering
Reference no: EM13713192

A shell-and-tube heat exchanger is used to cool a flow of steam using a stream of cooling water. The steam enters the heat exchanger at 0.1 bar and a quality of 91% (state 1), and exits as a saturated liquid at the same pressure (state 2). The mass flow rate of the steam is 2.6 · 105 kg/hour. The cooling water enters the heat exchanger at 5 MPa and 15oC (state 3) and exits at 38oC at the same pressure (state 4). The cooling water can be treated as an incompressible liquid. Neglect stray heat transfer and neglect kinetic and potential energy effects. As well, assume the system is operating under steady-state conditions.

a) Determine the mass flow rate of cooling water in kg/s.

b) Determine the rate of heat transfer between the steam and the cooling water in MW.

Reference no: EM13713192

Previous Q& A

  Identify parameters

Read (a,b,c); if(a!=0){d=b*b-4*a*c;if(d

  What is the angular velocity of the bicycle

A bicyclist starts at rest at the top of a 50.3m long hill. After a small push, he coasts speeding up with an acceleration of 3.43m/s2 due to the slope of the hill. What is the angular velocity of the bicycle tires at the bottom of the hill.

  Electrical work is employed to heat

Electrical work is employed to heat 2kg of water from 298.15 K to 373.15 K. Determine the electrical work required, and the minimum work required (e.g., by using a heat pump instead).

  Write a summary of the book born to buy

You need to write a summary of the book born to buy.

  The crankshaft in a given automobile rotates

The crankshaft in a given automobile rotates, on average, at 2500 revolutions per minute for a period of 2 h per day. How long would it take before the crankshaft has been subjected to 10^8 load cycles?

  Energy conservation and availability balance equation

Water vapor at 300 C, 35 bars (state 1) expands to 5.0 bars (state 2) using an adiabatic throttling valve. The ambient is at T = 25 C, 1 bar. Simplify the energy conservation and availability balance equation for the current problem. Calculate the ex..

  What is the internal resistance of the battery

A battery has an emf of 15.0 V. The terminal voltage of the battery is 13.4 V when it is delivering 16.0 W of power to an external load resistor R. What is the internal resistance of the battery.

  Landing gear on a commercial aircraft experiences

The landing gear on a commercial aircraft experiences an impulse load upon landing. Assuming seven such landings per day on average, how long would it take before the landing gear has been subjected to 108 load cycles? (Answer in years)

  Same mass is added through both inlets

An initially empty, well insulated, rigid tank with a volume of 2 m^3 is fitted with a mixing device. The tank has two inlets and zero outlets. One inlet is water at 1.07 MPa and 630ºC while the other is saturated liquid water. Both enter the tank sl..

  Persuasion persuasive speech outline

Public speaking and persuasion Persuasive speech outline -

Reviews

Write a Review

 

Similar Q& A

  Actual power plants operating with solar energy

Consider two actual power plants operating with solar energy. Energy is supplied to one plant from a solar pond at 80°C and to the other from concentrating collectors that raise the water temperature to 600°C. Which of these power plants will have a ..

  What is a plasticizer consider a polymer with a plasticizer

what is a plasticizer? consider a polymer with a plasticizer. how the crystallinity of polymer will be affected by

  The room temperature yield strength of ni is 100mpa 15000

the room temperature yield strength of ni is 100mpa 15000 psi and furthermore sy diminishes about 5mpa for every 50

  In a well-insulated continuous glass melter propane gas

in a well-insulated continuous glass melter propane gas c3h8 is used as fuel with 100 excess 300k air for combustion.a

  Estimate the true strain epsilonzz at the base of the

a circular cylinder of tantalum with an initial diameter of 3.1 mm is fired at a target. during impact the base of the

  What is the value of the capacitance c2 that should be

the capacitance in a series rcl circuit is c1 2.74 ?f and the corresponding resonant frequency is f01 6.57 khz. the

  Also venous blood enters at 0 mm hg and leaves at 15 mm hg

imagine that the heart acts as a pump. blood enters the heart from the lungs at 6mm hg and leaves to the rest of the

  A line containing nitrogen at 540or and 75 psi is connected

a line containing nitrogen at 540or and 75 psi is connected to a turbine that exhausts to an initially empty closed

  Determine the required diameter for the uniaxial tensile

determine the required diameter for the uniaxial tensile loaded two-force component if the failure criterion is

  A vertical jet of water leaves a nozzle at a velocity of 10

a vertical jet of water leaves a nozzle at a velocity of 10 ms and a diameter of 20 mm. it suspends a plate having a

  How does tension spread over the line abad

A small boat hangs from two davits, one of which is shown in the figure. The tension in line ABAD is 82 lb, determine the moment about C of the resultant force exerted on the Davit.

  Calculate the analysis of the wet product of combustion

In the actual combustion of benzene in an engine the A/F ratio was 12/1. Calculate the analysis of the wet product of combustion. A thermometer inserted into an air steam flowing at 33.5 m/s records a temperature of 15 degree Celsius; the static pres..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd