Modify the subroutines written in assembly program

Assignment Help Mechanical Engineering
Reference no: EM131090207

Some computers have a swap instruction. Modify the subroutines shown in Program 5.14, written in 9S12 assembly language, to implement a binary spin-lock semaphore using this fictional instruction. The system must provide for mutual exclusion. You may not disable interrupts. Do not use the minm instruction. The syntax of this fictional atomic operation is

1102_ddb34b38-1a99-4013-b52f-e2382f9d921b.png

Where Operand is any standard 9S12 addressing mode and r is any of the 9S12 registers. This instruction exchanges the 8- or 16-bit contents of the Operand and data register. It does not set any condition code bits.

Program 5.14

1375_d58bfe0a-9ed6-406a-9adb-de61f5c18c2e.png

Reference no: EM131090207

Design a forced-air heating and cooling system

Design a forced-air heating and cooling system for one of the top-floor apartments and one of the lower-floor apartments in Appendix A based on the geographic location where

What materials can this method measure

Write an academic style paper fourpages (double spaced) in length with at least three references. Web references, including commercial sites, are preferred. It is recommende

Determine the reaction forces

Ignoring the weights of the arms, determine the couple M required to cause the drum to rotate counterclockwise at a constant speed. Also, determine the reaction forces at A,

Explain why the radiation leaving an enclosure

Explain why the radiation leaving an enclosure (e.g. an oven kept at temperature T) through a small hole is a very good approximation for blackbody radiosity at temperature T.

Specific enthalpies at entrance and exit of all components

A jet plane cruises at a speed of 980 km/hr. air enters the turbojet engines at 0.73 bar, 230 k. the pressure ratio across the compressor is 10 and the turbine inlet temperatu

Determine the range of air velocities

The characteristics at both low speed (approximately 20 mph) and high speed (90 mph) are of interest. For a series of projected model tests, a wind tunnel that will accommod

Determine the required brine flow rate

Assuming the brine has the properties of water, determine the required brine flow rate, the required effectiveness of the heat exchanger, and the required heat transfer surf

Calculate the pressure drop through the tubes

calculate the pressure drop through the tubes for each selection. Recommend a final design that specidies water-flow rate, tube size, number of tubes, and tube length. Comme

Reviews

Write a Review

 
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd