+1-415-670-9189
info@expertsmind.com
It is pressurised internally until the outer layer surface
Course:- Mechanical Engineering
Reference No.:- EM13601525





Assignment Help >> Mechanical Engineering

A thick cylinder has an inside diameter of 60 mm and an outside diameter of 100 mm. It is pressurised internally until the outer layer (surface) has a hoop stress of 300 MPa. Calculate the pressure on the inside surface.




Put your comment
 
Minimize


Ask Question & Get Answers from Experts
Browse some more (Mechanical Engineering) Materials
Determine the horsepower required to overcome the drag on a streamlined car traveling at 90 km/hr. The drag coefficient C is 0.2, and the drag force is Fp = .5pv^2AC. Where A
A regenerative steam power cycle has a closed feed water heater that heats 20 kg/s of water from 100°C, 20 MPa to 250°C, 20 MPa. The extraction steam from the turbine enters t
Air enters a one-inlet, one-exit control volume at 6 bar, 500 K, and 30 m/s through a flow area of 28 cm2. At the exit, the pressure is 3 bar, the temperature is 456.5 K, an
You arrived on an alien planet and are tasked with finding conversions between Earth units and alien units. You found that 3.914 liters are equal to 1 gorblox. How many liters
Ecological footprints measure humankind's demands on nature. Using the Internet, estimate the amount of land and water needed annually to support your con- sumption of goods
Suggest an appropriate material for each of the following applications, and, if necessary, recommend corrosion prevention measures that should be taken. Justify your suggest
The garment may be assumed to have a temperature of 25°C and a characteristic length of 1 m in the vertical direction. Estimate the drying rate per unit width of the garment
1 A simple cycle stationary gas turbine has compressor and turbine efficiencies of 0.85 and 0.9, respectively, and a compressor pressure ratio of 20. Determine the work of t