How much does the aggregate in the wheel barrow weigh

Assignment Help Civil Engineering
Reference no: EM13310590

You fill a 2 cubic foot wheelbarrow to the top with aggregate. If the specific gravity of the aggregate is 2.548 and 18% of the aggregate is void spaces, how much does the aggregate in the wheel barrow weigh?

Reference no: EM13310590

Questions Cloud

Explain the change in temperature of the calorimeter : Delta H of combustion of benzoic acid is 3.22 x e3 kJ/mol. 0.5 g of benzoic acid was burned in a calorimeter containing 1000.0 g of water. The change in temperature of the calorimeter was 3 degrees C. Calculate the heat capacity of the calorimeter..
Find the maximum kintetic energy of electrons : The wavelength associated with the cut-off frequency for silver is 325 nm. Find the maximum kintetic energy of electrons
Determine the clean filter head loss in filter bed composed : Determine the clean filter head loss in a filter bed composed of 0.3 m of uniform anthracite (with an average size of 1.6 mm) placed over 0.3 m of uniform sand ( with an average size of 0.5 mm) for a filtration rate of 160 L/m^2.min.
Explain the enthalpy of vaporization of ethanol : The enthalpy of vaporization of ethanol is 38.7 kJ/mol at its boiling point (78°C). Calculate the value of DeltaSsurr when 1.00 mole of ethanol is vaporized at 78.0°C and 1.00 atm
How much does the aggregate in the wheel barrow weigh : You fill a 2 cubic foot wheelbarrow to the top with aggregate. If the specific gravity of the aggregate is 2.548 and 18% of the aggregate is void spaces, how much does the aggregate in the wheel barrow weigh
Why does http at the application layer uses tcp : Why does HTTP at the application layer uses TCP while DNS uses UDP when it passes its message packet with overhead to the Transport Layer and then hand it off to the Network Layer?
What is the distance between nodes : A guitar string is fixed between two points, 53.0cm apart. Its linear density is 12.0g/m. Now suppose the string is vibrating in its third harmonic. What is the distance between nodes
Explain what is this formula in terms of delta-p : What formula is used to find the work needed to compress water from atmospheric pressure to a higher pressure (with ambient Temperature)? I know about w = integral (-PdV), but V is constant. What is this formula in terms of delta-P
Design simple horizontal curve to connect roadway tangents : Design a simple horizontal curve to connect two roadway tangents that deflect at an angle chosen between 50 and 75 degrees. Assign a station to the curve PI and select a curvature of 6 degrees.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the maximum load p that the member can support

A stainless steel tube with an outside diameter of 65 mm and a wall thickness of 5 mm is used as a compression member. If the axial normal stress in the member must be limited to 180 MPa, determine the maximum load P that the member can support.

  Estimate the cost of a similar ethanol unit with a capacity

The cost of a 100,000 bbl/d ethanol unit is $40,000,000. From historical records, the capacity exponent ratio for CCR is 0.75. Estimate the cost of a similar ethanol unit with a capacity of 135,000 bbl/d.

  List three intensive and two extensive properties of apple

an apple weighs 60g and has a volume of 75cm^3 in a refrigerator at 8 degrees C. What is the apple's density List three intensive and two extensive properties of the apple.

  Calculate the difference in heat loss through the roof

Your family cabin now has a roof that is rectangular, 60 feet by 20 feet, and is covered by 2 inch thick hardwood siding and tapped wood shingles. You propose adding 2 inches of cellulose fiber insulation under the hardwood.

  At what temperature change delta t does the wire go slack

a brass wire of diameter d=1/6 in is stretched between rigid supports with an initial tension T of 37lb. assume the coefficient of thermal expansion is 10.6X10^-6 / F and the modulus of elasticity is 15X10^6 psi.

  Thermo-gravimetry of calcium oxalate

Evaluate the percent mass loss for each of the three thermal events indicated on the attached TGA trace

  Can contractor claim that liquidated damages should in limit

Can a contractor claim that liquidated damages should be limited Because of political unrest, only 20% of rooms are occupied. Liquidated damages are set to $30000 per day -> reasonable amount Contractor is late 15 days.

  What is its specific gravity at 30 percent moisture content

The cross sectional dimensions of a 4-ft-long wood member at 30% moisture content is 1.5 in. x 7.5 in., and its weight is 11 lb. At oven-dry condition, its dimensions and weight are 1.35 in x 6.8 in., and 10.2, respectively. What is its specific g..

  Determine the force members bc, fc, and fe

Determine the force members BC, FC, and FE, and state if the members are in tension or compression.

  Define what is the federal express philosophy toward quality

What is the Federal Express philosophy toward quality? What specific elements/actions has FedEx implemented in its quality improvement history?

  Find the value of the kinetic energy correction coefficient

assuming that the velocity variation within the main channel and the floodplain subsections is much smaller than the change in mean velocities between subsections, find the value of the kinetic energy correction coefficient.

  Calculate vapor pressure-air pressure and relative humidity

Calculate the vapor pressure, air pressure, relative humidity, and air density at elevation 1500 m if air temperature is 25 degrees C and dew point temperature is 20 degrees C and the lapse rate is 9 degrees C/km

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd