How many decibels is system inferior to dsb- sc modulation

Assignment Help Electrical Engineering
Reference no: EM13225996

The average noise power per unit bandwidth measured at the front end of an AM receiver is 10^(-3) watt per Hertz. The modulating wave is sinusoidal, with a carrier power of 80 kilowatts, and a sideband power of 10 kilowatts per sideband. The message bandwidth is 4 kHz. Assuming the use of an envelope detector in the receiver, determine the output signal-to- noise ratio of the system. By how many decibels is this system inferior to a DSB- SC modulation system?

Reference no: EM13225996

Questions Cloud

Journal of applied social psychology : Evaluate the findings of the authors in regards to the attitudes of teachers of different ethnic origins in Malaysia towards an outcome-oriented performance appraisal.
Geographic isolation-representative of japanese taste : Japan was left in peace for thousands of years because of its geographic isolation.  Toward the end of the twelfth century, the emperor and his court were dominated by a warrior society in Japan.  These developments, especially the power exerted by t..
Compute the hear of formation of b2o3 : When 1.00 g of Boron is burned in O2 (g) to form B2O3 (s), enough heat is generated to raise the temp of 733 g of water from 18.0 deg C to 38.0 deg C. Calculate the hear of formation of B2O3(s) under these condtions.
Compute a seasonalized or adjusted sales forecast : Season indices for the four quarters have been found to be 1.30, 0.90, 0.70, and 1.10 respectively. Compute a seasonalized or adjusted sales forecast.
How many decibels is system inferior to dsb- sc modulation : The average noise power per unit bandwidth measured at the front end of an AM receiver is 10^(-3) watt per Hertz. The modulating wave is sinusoidal, with a carrier power of 80 kilowatts, and a sideband power of 10 kilowatts per sideband.
Explain what was the mass percentage of the chloride : An excess of aqueous silver nitrate, AgNO3 was added to precipitate the bromide ion as silver bromide. If 8.00g of the soluble salt produced 2.00g of silver bromide, what was the mass percentage of the chloride in the sample?
What is the correspoding carrier- to - noise ratio : An AM receiver, operating with a sinusoidal modulating signal and 80 percent modulation, has an output signal-to-noise ratio of 30 dB. a) What is the correspoding carrier- to - noise ratio
Human population-atmospheric pollution-water resources : If you were an environmental researcher and were given funding to assist with one environmental issue, which of the following topics would you choose to spend your funds on?
What source screening activities are available to a supply : What source screening activities are available to a supply manager for critical procurements? Describe each one.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain what are the distinguishing features of the response

What are the distinguishing features of the response in the pass-band? What are the distinguishing features of the response in the stop-band? What is an all pass filter?

  Explain absorption loss of metal shielding

Absorption loss of metal shielding, A plane metal shield offers an absorption loss of 30 dB at a frequency of 10 kHz to normally incident radiated emission.

  How much charge passes through a cross section

the ends of a length of wire are labeleda and b. If the current in the wire is iab = -3A, are electrons moving toward a or b? How much charge passes through a cross section of the wire in 3 seconds?

  Develop the pseudo-code

Develop the pseudo-code below for a program that will retrieve 2 bytes (NUM1 and NUM2) from memory, determine which is closest to the numeric value 50, and indicate the result by setting a variable named "CLOSEST" to 1 (if 1st byte is closest) or ..

  Evaluate laplace transforms

Analyse and Model Engineering Situations and Solve Engineering Problems using Laplace Transform

  Determine the value of the output voltage

Determine the value of the output voltage due to the voltage source only (Vol), and due to the current source only (V02).

  Calculate the current in the output of the source

Calculate the current in the output of the source before and after the installation of the new device and The temperature sensor output is a voltage which is equal to the temperature sensed by the sensor. Design an electric circuit which can get th..

  How tall must the antennas be if the link operates

How tall must the antennas be if the link operates on a frequency of 2.450Ghz, D1=5miles, D2=11miles, and the obstruction is 60 feet high?

  Explain current to voltage op amp circuit

Current to Voltage Op Amp Circuit, A 12-bit DAC (Digital to Analogue Converter) gives an output range of 0 to 1 mA for a digital input word of 0 to 4095

  Consider a coffee counter with a single server

Consider a coffee counter with a single server at which tired students arrive according to a Poisson process. Let the mean arrival rate be two students per ten minutes and assume the serving time is exponentially distributed with an average of 180..

  Explain a sinusoidal voltage has a maximum value

A sinusoidal voltage has a maximum value of 100V, and the value is 10V at t=0. The period is T=1ms. Determine the angular frequency, w, in rad/sec.

  Design a collision free circuit for a router

A network router connects multiple computers together and allows them to send messages to each other. If two or more computers send messages simultaniously, they collide and the messages must be resent. Design a collision free circuit for a router..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd