How many charges need to move across the membrane

Assignment Help Electrical Engineering
Reference no: EM13219137

During an AP, the membrane potential typically moves from -70mV to +20mV and back again. In a cell with 10um radius and 1uF/cm^2, how many charges need to move across the membrane (and back again) to get this 90 mV voltage fluctuation?

Reference no: EM13219137

Questions Cloud

Compute profit maximizing level of price and output level : the industry demand function for bulk plastics is represented by the following equation: P=800 - 20Q where Q represents millions of pounds of plastic. the total cost function for the industry, exclusive of a required return on invested capital, is..
Identify the challenge areas : The options should provide sufficient detail so that Brian can decide what to do. Information from Part A should be used as background (input) into the go-forwardoptions outlined in your report.
Calculate the percent increase is attenuation : Rayleigh Scattering. Calculate the % increase is attenuation due to Rayleigh scattering exhibited by light having a free-space wavelength 1535 nm as compared to light having a free space wavelength 1550 nm. Provide your answer in units of [%] and ..
Describe rapid growth and consistently profitable operations : BearKat Tech Services (which provides enterprise network security services as well as providing technology consulting services to oil & gas firms) and East Texas Technnolgy (which specializes in software products for the oil and gas industry). Wh..
How many charges need to move across the membrane : During an AP, the membrane potential typically moves from -70mV to +20mV and back again. In a cell with 10um radius and 1uF/cm^2, how many charges need to move across the membrane (and back again) to get this 90 mV voltage fluctuation?
Find the smallest possible diameter : A micrometer caliper is used to measure the diameter of a bolt and a reading of 0.768 inches is obtained. Based on this measurement, find the smallest possible diameter and the largest possible diameter.
Marginal profit problem : In the very first year of operations, we would aim at selling close to 100,000 bottles of the deodorant, thus generating total revenue of US$1.1mn. Assuming in the very first year the SG&A expenses will be pretty higher, we assume to breakeven in ..
What are the advantages of using a counter : In a Built in Self Test, for a combinational logic system, what are the advantages of using a counter instead of an ALFSR to generate testing vectors for 2 cases.
What are the drawbacks to developing resources offshore : What are the drawbacks to developing resources offshore?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain the significance of these intersections

construct a vertical line on your I versus V graph at the point V=5V. this line will intersect each of the sloping lines at two separate points. explain the significance of these intersections.

  Explain combinational versus sequential circuits

(Combinational versus Sequential Circuits) Which of the fol¬lowing contain circuits that are likely to be combinational and which contain sequential circuits? Explain your rationale.

  Define differences in the theoretical and measured values

Include worked solution, a discussion of any differences in the theoretical and measured values and screenshots that show your measurements and paste them into a document

  What are the names of the three regions of the bipolar

What are the names of the three regions of the bipolar junction transistor? Why is there a thin region of one material type

  Use the fourier series analysis integral to compute

Draw a labeled sketch of x(t) over a few periods: be careful, make sure you follow the exact definition of x(t)

  Explain saturated and unsaturated synchronous reactance

Saturated and unsaturated synchronous reactance, The following readings are taken from the results of an open- and a short-circuit test on a 9375-kVA three-phase Y-connected

  Measurements show that for a particular arrangement

Measurements show that for a particular arrangement of the equipment and at a particular amplifier setting, the system will howl if 1% of the output power is fed back to the microphone. Estimate the power gain of the P.A. amplifier in decibels.

  What does the documentation mean

Using the Internet, a magazine, or a provided list of memory modules, determine the exact part numbers and quantities of memory modules that you would buy. List them with the location of where you obtained the information.

  Define the transmission line has an impedance

The transmission line has an impedance of 600 ohms and is terminated in a load of 600 ohms. The transmitter delivers an average power of 0.1 W to the input of the line.

  Explain memory storage and bit density

Memory storage and bit density, A hard disk contains four Platters. Each side of the platter is coated with a magnetic oxide, allowing data to be stored on it. The platters are 3.5 inches in diameter.

  Consider a direct sequence spread spectrum

Consider a direct sequence spread spectrum (DSSS) system attempting to transfer data. The DSSS system has a data rate of 2 Kbps (2 thousand bits/sec) which is spread to 2 Mcps

  Calculate the traffic load per cell

The system uses a 7-cell reuse pattern. If the offered traffic per user is 0.03 Erlangs and the average number of calls per hour per user is 1.5, for an Erlang-C system with a probability of delaying a call being 5%, calculate the traffic load per..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd