Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Consider two alternatives for designing an amplifier having a dc gain of 100. The first alternative is to use a single non-inverting stage, having a gain of 100.The second alternative is to cascade two non-inverting stages, each having a gain of 10. Op amps having a gain bandwidth product of 106 are to be used. Write an expression for the gain as a function of frequency for each alternative. Find the 3-dB bandwidth for each alternative.
This bar is made of AISI 1006 cold-drawn steel and is loaded by the forces F=0.55 kN and T=25.N.m. Use both the maximum-shear theory and the distortion-energy theory to design the bar diameter D.
The lithographic system A uses KrF excimer laser source (248 nm) while the lithographic system B uses the I-line of a Hg lamp (365 nm) as the photon source. Give two main shortcomings of the e-beam lithography
A simple power system consists of a dc generator connected to a load center via a transmission line. The load resistance is 8 ohms. The transmission line is 40km copper wire of 4 cm diameter. If the voltage at the load side is 400 V, compute Volta..
At t=40s, the capacitor is disconnected from the charging circuit and connected in parallel with a 5- Mega ohm resistor. Determine the voltage across the capacitor at t=40s and at t=100s.
A six pole, 400 V d.c. motor draws 110 A from the supply. The shunt field resistance is 200 Ohm and the armature resistance is 0.5 Ohm. The armature is wave wound with 600 conductors operates at a speed of 1200 rev/min when supplying full load.
With the internal resistance of 0.14Ω, what will be the minimal load resistance to ensure at least 84 percent of the power delivered by the battery goes to the load
What is the name given to the process of assigning a specific binary number to an instantaneous value on an analog signal
State the advantages of digital versus analog quantities.
one group of students made an error by using HCLinstead of H2SO4 to titrate an unknown solution of NaOH. Would this error change the calculated molarity of the NaOH solution.
Design a static CMOS inverter with long channel transistors and a. switching voltage VM of 0.6 VDD. What is the resulting ratio of WP/WN b. switching voltage VM of 0.45 VDD. What is the resulting ratio of WP/WN
On a logarithmic vertical axis from 1ohm to 1Gohm, and a logarithmic horizontal axis from 1rad/sec to 10^9 rad/sec, sketch the following: a) A 1 kOhm resistor and a 1 mH inductor in parallel and (separate curve) in series.
Determine the output y(t) if the input to the system is given by x(t) = u(t) - u(t-2) using complex-domain (not time-domain) analysis techniques.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd