Find the maximum linear speed of any part of the bit

Assignment Help Physics
Reference no: EM13278485

According to the shop manual, when drilling a 12.1-mm-diameter hole in wood, plastic, or aluminum, a drill should have a speed of 1400 rev/min.

1. For a 12.1-mm-diameter drill bit turning at a constant 1400rev/min , find the maximum linear speed of any part of the bit.

2. Find the maximum radial acceleration of any part of the bit.

Reference no: EM13278485

Questions Cloud

Explain the number of moles of co2 : Determine the number of moles of CO2 that could be produced from the combustion of 0.00993 moles of Benzene
What impulse was given to the ball by the floor : A ball of mass 0.120 kg is dropped from rest from a height of 1.25 m. What impulse was given to the ball by the floor
Find out the number of moles of oxygen : Determine the number of moles of oxygen that would be needed to completely combust 0.0350 moles of benzene
Define what is the blood calcium levle : A pt has a blood Ca level of 4.6 mEq/L If 1mol Ca2+= Eq Ca2+ what is the blood calcium levle in mg/dl
Find the maximum linear speed of any part of the bit : According to the shop manual, when drilling a 12.1-mm-diameter hole in wood, plastic, or aluminum, a drill should have a speed of 1400 rev/min. find the maximum linear speed of any part of the bit
Define what is the ph of a solution containing : What is the pH of a solution containing 50.00 mL of 1.0 M HCl and 50.00 mL of 1.0 NH3? The Kb for NH3 = 1.8 x 10-5.
Determine the speed of the three coupled cars : A railroad car of mass 3.4 x 104 kg moving at 4.00 m/s collides and couples with two coupled railroad cars, What is the speed of the three coupled cars after the collision
Explain good professor accidently grabs the na2hpo4 bottle : The good professor accidently grabs the Na2HPO4 bottle. What pH did professor Whoops expect the solution to be. what was the actual pH of the solution as made
Using graphical techniques and calculate the distribution : Using graphical techniques, calculate the distribution (i.e., the fraction) of chlorendic acid ( in uncharged, mono-anionic and di-anionic forms) at pH 3.5,5.0, and 7.5.

Reviews

Write a Review

Physics Questions & Answers

  What is the damping constant of the oscillation

A mass of .500 kg is connected to a spring of spring constant 30 N/m. The oscillation begins by pulling the mass to the right to amplitude 0.40 m before release, what is the damping constant of the oscillation

  Total translational kinetic energy of the gas molecules

A professor's office door is 0.94 wide, 2.2 high, 4.0 thick; has the mass of 23, and pivots on frictionless hinges. A "door closer" is attached to door and top of the door frame. When the door is open and at rest, the door closer exerts a torque of 5..

  Find the magnitude of the electrons acceleration

An electron passes through a point 3.27 cm from a long straight wire as it moves at 37.3% of the speed of light, Find the magnitude of the electron\'s acceleration at that point

  Determine the angle of the total acceleration

In a fast-pitch softball game the pitcher is impressive to watch, Determine the angle of the total acceleration relative to the radial direction

  How thick is the oil film

A thin film of oil (n = 1.24) is located on a smooth, wet pavement. When viewed perpendicular to the pavement, How thick is the oil film

  What maximum altitude does the rocket reach

A rocket rises vertically, from rest, with an acceleration of 4.0m/s2 until it runs out of fuel at an altitude of 1400m. After this point, What maximum altitude does the rocket reach

  Determine the distance between the two ships

Ships A and B leave port together. For the next two hours, What is the distance between the two ships two hours after they depart

  What is the maximum height the ball goes above the ground

A soccer ball is kicked with an initial horizontal velocity of 18 m/s and an initial vertical velocity of 13 m/s, What is the speed of the ball 0.8 seconds after it was kicked, What is the maximum height the ball goes above the ground

  Why it is important to stop the recoil of the cannon

In one design, the large spring with spring constant 2.0×10^4 was placed behind the cannon. The other end of the spring braced against a post that was firmly anchored to the ship's frame.

  Compute the average power delivered to this circuit

A 3700 ? (ohm) resistor and a 1.2-µF capacitor are connected in series across a generator, Determine the average power delivered to the circuit

  A gun is fired vertically into a 2.00 kg block of wood

A gun is fired vertically into a 2.00 kg block of wood at rest straight above it. If the bullet has a mass of 21.0 g and a speed of 198 m/s, how high would the block rise into the air after the bullet becomes embedded in it.

  Determine the value of the electric potential

Determine the value of the electric potential. calculate the acceleration of the ball when it is 3 cm from the surface and again at the position determined in part b.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd