Find the coefficient of friction at the stopping point

Reference no: EM13563426

A box is sliding with a speed of 4.50 m/s on a horizontal surface when, at point P, it encounters a rough section. On the rough section, the coefficient of friction is not constant but starts at .100 at P and increases linerly with distance past P, reaching a value of .600 at 12.5 m past point P.

(a) Use the work energy theorem to find how far this box slides before stopping.

(b) What is the coefficient of friction at the stopping point?

(c) How far would the box have slid iff the friciton coefficient didn't increase, but instead had the constant value of .1?

Reference no: EM13563426

Questions Cloud

Persuasive speech about stem cells : A persuasive speech about using stem cells in spite of the ethical issues.

The coefficient of friction between the block and the board : A 2.00-kg block slides down a board 1.50 mlong which is inclined at an angle of 40.0°. The coefficient of friction between the block and the board is 0.200. Find the work done by each force that acts on the blockas it slides from the top to the botto..

Determine the magnitude of the compression force : The person weighs 170 lb. Each crutch makes an angle of 22.0with the vertical. determine the magnitude of the compression force supported by each crutch

Evaluate the current in the rods : Two rigid rods are oriented parallel to each other and to the ground. The rods carry the same current in the same direction. Determine the current in the rods

Find the coefficient of friction at the stopping point : A box is sliding with a speed of 4.50 m/s on a horizontal surface when, at point P, it encounters a rough section. What is the coefficient of friction at the stopping point

Find velocity of each block immediately after collision : A block of mass m is slides down africtionless inclined surface. The height of the block changes from h at the top to zero at the bottom of theincline. The block then slides across a frictionless horizontal surface and collides elastically with as..

State how many energetically different eclipsed conformation : How many energetically different eclipsed conformations does 1-bromo-2-methylpropane, viewed along the C1- C2 bond, have

Determine the rms voltage across the inductor : An 87.6-mH inductor anda 6.37-µF capacitor areconnected in series with a generator whose frequencyis 391 Hz. The rms voltage across the capacitor is 2.26V. Determine the rms voltage across the inductor.

A converging lens has a focal length : A converging lens has a focal length of 25.0 cm. A ruler (30.0 cm in length) is located 50.0 cm in front of the lens and oriented at an angle of 90 degrees to the principal axis, as shown below. What are the a) location and b) height of the image?

User Account

All Pages