Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Question about Examination of a digital radio link
A digital radio link is designed to carry a T1 rate digital signal (1.544 Mbps). The transmitter and receiver have ideal RRC bandpass filters with roll off factor (r) = 0.2.
a. What RF bandwidth must the radio link provide if the modulation is binary phase shift keying (BPSK)?
b. The link is unchanged but the modulator and demodulator in the transmitter and receiver are changed to transmit and receive QPSK. The link has the bandwidth you found in part (a) above. What is the maximum bit rate that the link can carry using QPSK modulation?
c. If the filters in the transmitter and receiver are changed for ideal RRC filters with roll off factor (r) = 0.5, what is the maximum symbol rate for this link?
Write a short report that analyses the P&ID - Basic Neutralizer Control System: The neutralizer process may be used to adjust the pH of a feed stream.
What is the peak frequency deviation of the FM signal? What is the FM improvement in dB?
What is the problem you are investigating and explain the issue, its history, the impact it makes locally
What is the quantization signal to noise ratio SNRQ at the receiver output? e. If the SNRQ were to be raised to 96 dB, how many bits would the ADC and DAC need? What would be the bit rate on the serial link?
Determine the phase relation between V o and i g for the given network if V g = 45sin(317t) and determine v o for the given network
The purpose of this project is to design a device that would remotely control (from a Bluetooth-enabled mobile phone for instance) at least two actuators (e.g. relays and switches).
A 1 kHz sine wave signal with a power level -10 dBm is applied to the input of the amplifier. What is the power at the amplifier output in dBW?
You have to figure out which one using cross or auto correlation.
The location of the zeroes in the spectrum suddenly changes to 5 kHz, 10 kHz, 15 kHz.... What parameter of the rectangular pulses has changed and what is its new value?
Capacity, Data and Transfer Rates, Access Time of Disk Drive, A hard disk drive has 10 disks and 18 surfaces available for recording. Each surface is composed of 200 concentric tracks and the disks rotate at 7200 r.p.m.
A baseband sine wave signal with frequency 4.0 kHz is modulated onto a carrier at 1.050 MHz using DSB-LC AM. What are the frequencies of the sidebands of the RF signal?
Murray Loop Test and Locating Faults, Q.1 (a) Using the Murray Loop test, determine the distance to an earth fault on one of the cores of a uniform three-core underground cable. Ra = 2 ohms, Rb = 1 ohm
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd