Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Data at a rate of 2 Mbps is to be transmitted via a pass-band communication system whose carrier frequency is 500MHz. A binary antipodal system with roll-off factor of 0.2 is used for this communication. The AWGN single-sided power spectral density at the receiver is found to be N0=10-12 W/Hz. 1) Evaluate the required received power that achieves a bit error probability of 10-6.
determine that the total field B within the sample is one tesla. Calculate M and determine what percentage of the volume now consists of domains with magnetization parallel to the field.
Memory storage and bit density, A hard disk contains four Platters. Each side of the platter is coated with a magnetic oxide, allowing data to be stored on it. The platters are 3.5 inches in diameter.
A baseband signal has frequency components from 5 kHz to 15 kHz. Determine (a) the theoretical minimum sampling rate and (b) the maximum time interval between successive samples.
What value of emitter resistor would you choose, if: a) You have to amplify the signal of a microphone that has an internal resistance of 100K using a Common Emitter bias configuration b) you have to drive a load of 50 with an Emitter Follower cir..
Write C code that senses 3 accelerometer readings into pins PAD 8, 9 and 10 and displays them on the LCD. Also run a timer in seconds and log the values of the accelerometers in 3 arrays every second.
The solar constant at Earth orbit (1 AU = 1 Astronomical Unit - Sun-Earth distance) is ~1400 Watts/m2. Assuming that this Poynting flux magnitude can be associated with a single E- and Hfield (i.e., E × H ),
what would the relative sensitivity of the IR detector be if you use FREQOUT to send a 35 kHz harmonic? What is the relative sensitivity with a 36 kHz harmonic?
The voltage and current in the Laplace domain for a certain system is given by V (s) = 1/12 1/s^2 +3, I(s) = s/s^2+3. Is this system best described as resistive, capacitive, or inductive?
A waveform generator is connected to an op-amp which has been setup as a voltage follower. The voltage follower is then loaded with a 50 Ohm resistor. What output impedance setting should the waveform generator use
Suppose a 12-V battery bank rated at 200 Ah under standard conditions needs to deliver 600 Wh over a 12-h period each day. If they operate at -10 Celsius, how many days of use would they be able to supply
Explain the difference between hard-decision and soft-decision decoding in partial response signaling, including the relative advantages and disadvantages of each.
A glass tube with a cross-sectional area of 9^-2 m^2 contains an ionizd gas. The densities are 10^15 positive ions/m^ and 10^11 free electrons/m^3. Under the influence of an applied voltage, the postive ions are moving.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd