+1-415-670-9189
info@expertsmind.com
Draw and annotate two ortho views
Course:- Mechanical Engineering
Reference No.:- EM131469658




Assignment Help
Expertsmind Rated 4.9 / 5 based on 47215 reviews.
Review Site
Assignment Help >> Mechanical Engineering

Draw and annotate two ortho views and a lengthwise section of the bracket shown below. Dimensions shown are in millimeters. Be sure all line work, hatching and annotation is on the correct layer. Use annotative  styles and place the drawings in your layout windows for printing.

1140_Figure.png

Attachment:- Assignment File.rar




Put your comment
 
View Conversion
Minimize
  1. user image
    len1469658

    Topic: AutoCad. Draw and annotate two ortho views and a lengthwise section of the bracket in the attached picture. Dimensions are shown in millimeters. Using the appropriate layers provided in the template. The drawing is set to object line, but there are also hidden layers in the template. All drawings are to be in 2-D. In the template, there is a layout for the drawings. These sections need to be included in these layout tabs as well.



Ask Question & Get Answers from Experts
Browse some more (Mechanical Engineering) Materials
what is the factor of safety for the footings against bearing failure if the clay soil has an unconfined compressive strenght of 3,600 psf? The back of the book says that fo
Sketch the configuration of a two-pole, four-stack, variable-reluctance stepper motor with two rotor teeth. Use as, bs, cs, and ds to denote the phase windings. Calculate TP
At resonance, the amplitude is measured to be 0.8 cm. At 0.85 resonant frequency, the amplitude is measured to be 0.6 cm. Determine the damping factor (zeta) of the system.
Determine the reverse thrust applied by the engine to the airplane. Assume the inlet and exit pressures are atmospheric and that the mass flowrate of fuel is negligible comp
A medical investigator is proposing to use radioactive spheres for thermal ablation of tumors. The idea is that the radioactivity will generate heat at a constant, uniform rat
Wait time after operation B is 5 hours, and the move time into stores is 3 hours. Queue at work center A is 25 hours and at B is 35 hours. Calculate the total manufacturing
Properties of long lines. A long line has parameters R, L, C, G = 0, and operates at 100 kHz. The characteristic impedance is Z0 = 300 - j10 Ω and the phase velocity on the li
A simply supported wide-flange beam of span length L carries a vertical concentrated load P acting through the centroid C at the midpoint of the span (see figure). The beam