Does the decoder have any performance drawbacks

Assignment Help Electrical Engineering
Reference no: EM131275982

Figure 12.83 shows a 3:8 decoder [Lyon87]. How does the logical effort of each input compare to an ordinary decoder made of 3-input NORs? Does the decoder have any performance drawbacks?

1765_b7643b12-46dc-451f-bc3c-5439aecb5c86.png

Reference no: EM131275982

Questions Cloud

Develop a model of wordline decoder delay for a ram : Assume true and complementary inputs are available and that the input capacitance equals the capacitance of one of the columns so H = 2m. Use static CMOS gates and express your result in terms of n and m.
Construct a table based on the duncans multiple range test : Construct a table based on the Duncan's multiple range test table concept that illustrates that the low and moderate income groups are not different from each other, but that the other groups are significantly different from one another.
Estimate the delay of the decoder : Estimate the minimum delay of a 10:1024 decoder driving an electrical effort of H = 20 using
What about unusual entrees versus unusual desserts : What about unusual entrees versus unusual desserts?- Perform the proper analysis and interpret your findings.
Does the decoder have any performance drawbacks : Figure 12.83 shows a 3:8 decoder [Lyon87]. How does the logical effort of each input compare to an ordinary decoder made of 3-input NORs? Does the decoder have any performance drawbacks?
Distinction between a statistical and a causal relationship : Explain the distinction between a statistical relationship and a causal relationship.- Relate the three different aspects of a relationship between two variables.
Describe or identify r by c table : With respect to Chi-square analysis, describe or identify r-by-c table, frequencies table, observed frequencies, and  expected frequencies.
How your personal values influenced the selection : In a 5-minute (or a 5-slide with notes) presentation, create an executive summary that recapitulates the issue and your proposed solution as well as a description of how your personal values influenced the selection and design of this program.
What is meant by the term significant correlation : What is meant by the term significant correlation?- Briefly describe the connections among the following: covariation, scatter diagram, correlation, and linear relationship.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the active power and the reactive power

The p.d. across and the current in a circuit are represented by (100 + j200) V and (10 + j5) A respectively. Calculate the active power and the reactive power.

  Develop a verilog model of the bcd decoder

Write Boolean equations for a BCD decoder, that is, a decoder that has a BCD code word as input and that has outputs y0 through y9. Draw a circuit that uses AND and OR gates and inverters to implement the decoder.

  Calculate the friction and windage-rotational losses

A six pole, 40 kW, 400 V d.c. motor draws 110 A from the supply. The shunt field resistance is 200 Ohm and the armature resistance is 0.5 Ohm. The armature is wave wound with 600 conductors operates at a speed of 1200 rev/min when supplying full l..

  Express the sampled sequence up to the fifth term

An exponential signal, x(t) = 4e-2t , is sampled at a frequency of 10 Hz, beginning at time t = 0. - Express the sampled sequence, x[n], up to the fifth term.

  Find how much current is flowing on the secondary side

Assume that a given transformer is 100% efficient; that is, the power being supplied by the primary side is transported without loss to the secondary side. (Transformers are not 100% efficient. One can detect this by the heat that they radiate.)

  What is the system power factor and supply current per phase

Three parallel three-phase loads are supplied from a 207.85-V rms, 60-Hz three-phase supply. The loads are as follows: Load 1: A 15 hp motor operating at full load, 93.25 percent efficiency, 0.6 lagging power factor.

  Evaluate surface integrals to find the total charge enclosed

Let D = 4xy ax +(2x2+2z2) ay + 4yz az nC/m2 and evaluate surface integrals to find the total charge enclosed in the rectangular parallel piped 0

  What is voltage present after ten second delay

In a power supply, a 150 microfarad capacitor was connected in parallel with a 200 kOhm resistor. The capacitor was maintained at a charge level of 350 volts DC. After power was removed for ten seconds, someone god a shock from touching the termin..

  Find electric field intensity of linear electric quadrupole

In the "far field" region, show that the electric field intensity of a linear electric quadrupole decays much faster in space than 1/R3 for the electric field intensity produced by an electric dipole and 1/R2 for an electric monopole.

  Determine that the positive peak of the output is delayed

A first order lowpass filter is operating in sinusoidal steady state conditions at a frequency of 2 kHz. It is determined that the positive peak of the output is delayed by 0.1 ms compared with the positive peak of the input.

  What is the regulator output voltage when the supply is high

Design a 7.5-V zener regulator circuit using a 7.5-V zener specified at 12mA. The zener has an incremental resistance r(z) = 30 ohms and a knee current of 0.5mA. The regulator operates from a 10-V supply and has a 1.2k-ohm load.

  Would the speed of rollers be adjusted based on measurement

Briefly, the speed is adjusted unless the probability that the mean thickness lies within ±2% of the sample mean exceeds 0.99. A typical set of measurements (in mm) is as follows:

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd