Devise a way to address words of memory using fewer n pins

Assignment Help Electrical Engineering
Reference no: EM13282335

As more and more memory is squeezed onto a single chip, the numberof pins needed to address it also increases. It is ofteninconvenient to have large numbers of address pins on a chip. Devise a way to address 2^n words of memory using fewer than n pins.

Reference no: EM13282335

Questions Cloud

What is the elements atomic mass number : An element in its solid phase forms a cubic crystal lattice with mass density 7950 kg/m^3. What is the element's atomic mass number
Calculate the gravitational attraction : Imagine two 5.0 g bags of protons, one at the earth's north pole and the other at the south pole. Calculate the gravitational attraction that each bag exerts on the other
Find what would to have in the hdl description : FPGAs are programmed from acompiled HDL description (i.e., a Verilog or VHDL program). What would you have to have in the HDL description to use the globalset/reset function in the Spartan FPGA
State the molar enthalpy of combustion for the compound : A 0.2254g sample of naphthalene (C8H10, 128.16g/mol) was burned in a bomb calorimeter with a heat capacity of 2.18kJ/K and temperature increased by 4.16 Celcius, what is the molar enthalpy of combustion for this compound
Devise a way to address words of memory using fewer n pins : As more and more memory is squeezed onto a single chip, the numberof pins needed to address it also increases. It is often inconvenient to have large numbers of address pins on a chip. Devise a way to address 2^n words of memory using fewer than n..
Define the ionic and net ionic equations : Write and balance the molecular equation and then give the ionic and net ionic equations for the neutralization reaction between NH3(aq) and H2SO4(aq).
Determine the minimum and the maximum values : An op-amp based amplifier has +/- 51 V supplies and a gain of -80.Over what input range is the amplifier linear. Find (a) the minimum and (b) the maximum values.
Explain carbon tetrachloride may react with oxygen : Carbon tetrachloride may react with oxygen to produce chlorine and carbonyl chloride.2CCl4(g) + O2(g) 2COCl2(g) + 2Cl2(g); Kc = 9.9 × 10^51. What is Kc for the following equilibrium?COCl2(g) + Cl2(g) CCl4(g) + ½O2(g)
Explain what is the equilibrium concentration of hii2(g) : In an experiment, 0.32 mol H2 and 0.32 mol I2 are mixed in a 1.00-L container, and the reaction forms HI. If Kc = 49. for this reaction, what is the equilibrium concentration of HI?I2(g) + H2(g) 2HI(g)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find current which flows in parallel resistor combination

4 resistors are connected in electrical parallel. R1=2 OHM, R2= 4 OHM, R3= 6 OHM, R4= 8 OHM. if this parallel resistor combination is placed across an ideal current source = 3A.

  Find expression for the slip at which maximum torque occurs

The expression for the torque of an induction motor as a function of its slip may be obtained by application of Thevenin's theorem to the circuit model. Show that the Zth obtained can be shown to be approximately equal to Zth = R1+JX1

  For what values of f in range sinusoid produce same sample

The continuous-time sinusoid x(t) = cos(300?t) is sampled every Ts = 2.0 ms, so that x[n] = x(0.002n) For what other values of f in the range 0 Hz to 2.0 KHz does the sinusoid v(t)

  What is the difference between d flip-flop and j-k flip-flop

What is the difference between a D flip-flop and a J-K flip-flop How does the number of inputs affect the possible synchronous states of a flip-flop (Set, Reset, Hold, Toggle)

  What are the best ar coating refractive index

Consider a Si phtodiode that is designed for operation at 900 nm. GIven a choice of two possible AR coatings, SiO2 with a refractive ndex of 1.4 and TiO2 with a refractive index of 2.3, which would you use and what would be the thickness of the AR..

  Find the phasor current in the direction of the voltage rise

A 40 Ω Resistor, a 5mH inductor, and a 1.25μF capacitor are connected in series. The series-connected elements are energized by a sinusoidal voltage source whose voltage is 600 cos(8000t + 20°) V.

  Identify the psk type and calculate the bandwidth for modem

i) Identify the PSK type and calculate the bandwidth if the modem is transmitting with 9600bps and 2400 baud.  ii) Suggest a way to reduce the baud rate to 1200 baud and calculate the new bandwidth.

  If loop consists of loop what is the radius along the loop

A current of 4 A flows through a wire forming a "loop" circle of radius r. If the magnetic field in the center of the "loop" is 10 A, what is the radius along the "loop": a) if the loop consists of a loop of wire, b) if the "loop" consists of 20 t..

  Compute the fractional loss for 1 km

If the attenuation coefficient for the wave in equation E =Eoe-αzsin(ωt - kz) has the value 2x 10-5 cm-1, compute the power loss in dB for1 km. Compute the fractional loss for 1 km.

  What is range of frequencies generated by local oscillator

Consider a superheterodyne FM receiver designed to receive the frequency band of 88 to 108MHz with IF frequency 10.7MHz. What is the range of frequencies generated by the local oscillator for this receiver

  Find the initial charge stored on the capacitance

A capacitance C is charged to an initial voltage Vi. At t = 0, a resistance R is connected across the capacitance. A) Write an expression for the current. Express your answer in terms of some or all of the variables R, C, Vi, and t.

  Setup the masm assembler and linker

The purpose of this experiment is to setup the MASM assembler and linker. This will allow you to write assembly language source files and create executable code, such as .EXE and .COM files

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd