Determine the water content

Assignment Help Civil Engineering
Reference no: EM13559049

In its natural condition a soil sample has a mass of 2400 g and a volume of 1.15 X 10-3 m3. After being completely dried in an oven the mass of the sample is 2225 g. The value of Gs for the soil is 2.7. Determine the:

a) bulk density

b) unit weight

c) water content

d) void ratio

e) porosity

f) degree of saturation and

g) air content.

Reference no: EM13559049

Questions Cloud

Estimate what is the position of the block : A block lies on a horizontal frictionless surface and isattached to the free end of a spring, with a spring constant of 60N/m. What is the position of the block
Estimate the hourly production and unit cost of rock : Estimate the hourly production and unit cost of rock excavation by drilling and basting. The rock is limestone having a seismic velocity of 6000 ft/s.
How many grams of ethane remainin the flask : A flask with a volume of 1.50 L, providedwith a stopcock, contains ethane gas (C2H6)at 300 K and atomospheric pressure (1.013 x 105Pa). How many grams of ethane remainin the flask
Literature review and report : Literature Review and Report
Determine the water content : In its natural condition a soil sample has a mass of 2400 g and a volume of 1.15 X 10-3 m3. After being completely dried in an oven the mass of the sample is 2225 g. The value of Gs for the soil is 2.7. Determine the:
What will be this maximum current : as LC circuit consists of a capacitor with C = 3.4 x10-6 F and an inductor with L = 0.080 H. What will be this maximum current
What is the dry unit weight, the saturated unit weight : What is the dry unit weight, the saturated unit weight, and the buoyant unit weight, of a soil having a void ratio of 0.5 and a value of Gs of 2.7?
Determine what is the mass of the aluminum cup : An aluminum cup contains 225 g ofwater and a 40 g copper stirrer, all at 27°C. Calculate the mass of the aluminum cup
Determine the cohesion and the angle of friction of the soil : Undrained shear box tests were carried out on a series of soil specimens with the following results:Total normal stress (kPa) Total shear stress at failure (kPa)

Reviews

Write a Review

Civil Engineering Questions & Answers

  Use the conveyance method to verify the results

A drainage channel had a cross section that may be approximated as a trapezoidal section with a bottom width of 15 feet and a side slope of 1.5H:1V. If the channel drops 2.5 feet per mile.

  What concentration is needed to maintain the phosphate

FeCl3 is added to remove excess phosphate. The following reactions occur (the charges are in parentheses): FeCl3 -> Fe(3+) + 3Cl(-) Fe(3+) + PO4(3-) -> FePO4

  Determine the deflection of a simple uniformly loaded beam

determine the deflection of a simple uniformly loaded beam by the ritz methodusing first one term then two terms adn

  Identify the planes on which they act by drawing the

For the case of the uniaxial compression, determine the maximum shear stresses that exist at that piont. Identify the planes on which they act by drawing the orientation of the element for these shear stresses. Show all stresses that act on the eleme..

  Explain how the foundation will be founded at a depth of 1m

Above the water table the soil mass unit weight is 16 kN/m^2. Below the water table the saturated unit weight is 19.5kN/m^2. The maximum column load is 330,000 lbs. Recommend the number and depth of borings.

  Estimate daily evaporation from a lake using penmans formula

Estimate daily evaporation from a lake (cm/day) using Penman's (combined) formula, given the following information: average air temperature is 28 oC, average water temperature is 15 oC, average wind speed at 8m height is 20 Km/hr

  Determine what is the maximum daily mass of chloride

The pipe has a flow of 5 m3/s. The stream's chloride concentration just upstream of the pipe's dischage is 12 mg/L, and the runoff pipe's discharge has a chloride concentration of 40 mg/L. Chloride is a conservative substance.

  What is the concentration of mlvss in the activated sludge

The concentration of Chemical Oxygen Demand (COD) in the effluent from this system is 25 mg L-1. The growth rate of the organisms in this case is 0.9 days-1. The activated sludge tank has a volume of 50 m3 and the flow rate through it is 500 m3 da..

  Determine the lengths of dg and cb of triangular tract

ABC is a triangular tract of land. The 1.5 tract DEFG is to be subdivided. AE is 480ft and DC is 350 ft. Determine the lengths of DG and CB. (Note 1 acre= 43,560 f^2)

  Calculate total mass emissions of particulates out of steck

The temperature in the stack is 300 F and the pressure is 725 mm Hg. If the total flow rate of gas out of the stack is 190 standard cubic meters per second, calculate the total mass emissions of particulates out of the stack in kg/day.

  Determine the mass distribution

If metal sorption to algae can be modeled by a Langmuir isotherm, determine the mass distribution (sorbed vs dissolved) of lead in the marsh.

  What is the maximum shear stress in the liquid

If the viscosity of the liquid is 10–3 N-s/m2, what is the maximum shear stress in the liquid?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd