Determine the power required to drive the compressor

Assignment Help Mechanical Engineering

Reference no: EM13713290

A certain industrial process requires a steady 0.75 kg/s supply of compressed air at 500 kPa, at a maximum temperature of 30C. This air is to be supplied by installing a compressor and after cooler. Local ambient conditions are 100 kPa, 20C. Using a reversible compressor, determine the power required to drive the compressor and the rate of heat rejection in the after cooler.

Reference no: EM13713290

Questions Cloud

Make a temperature contour plot using matlab : Consider a two- dimensional, straight triangular fin of Length L= 50mm and base thickness t= 20mm. The thermal conductivity of the fin is k= 25 W/mK. The base temperature is T_b= 50 degrees Celsius, and the fin is exposed to convection conditions cha..

Saturated steam is to be condensed on shell side of heat : Saturated Steam is to be condensed on the shell side of a heat exchanger at 75°F. Cooling water enters the tubes at 50°F at a rate of 45 lbm/s and leaves at 65°F. Assuming the heat exchanger to be well-insulated, determine the rate of heat transfer i..

Calculate the entropy change of the two reservoirs : Heat in the amount of 80 kJ is transferred directly form a hot reservoir at 985K to a cold reservoir at 280K. Calculate the entropy change of the two reservoirs and determine if the increase of entropy principle is satisfied kJ/K round to four decima..

Data for power cycle operating at steady state : Data for a power cycle operating at steady state between reservoirs at 1200 and 400 K is given. For each scenario determine the net power developed in kW and the thermal efficiency. Using the analytical form of the Claudius inequalities determine whe..

Determine the power required to drive the compressor : A certain industrial process requires a steady 0.75 kg/s supply of compressed air at 500 kPa, at a maximum temperature of 30C. This air is to be supplied by installing a compressor and after cooler. Local ambient conditions are 100 kPa, 20C. Using a ..

What is the mass flow rate of air : A compressor receives 0.1 kg/s R-134a at 150 kPa, -10C and delivers it at 1000 kPa, 40C. The power input is measured to be 3 kW. The compressor has heat transfer to air at 100 kPa coming in at 20C and leaving at 30C (i.e. like a heat exchanger). What..

Determine the fin efficiency : Consider a two- dimensional, straight triangular fin of Length L= 50mm and base thickness t= 20mm. The thermal conductivity of the fin is k= 25 W/mK. The base temperature is T_b= 50 degrees Celsius, and the fin is exposed to convection conditions cha..

Assumptions about the drop size and the unit cost of energy : A 1982 U.S. Department of Energy article (FS#204) states that a leak of one drip of hot water per second can cost $1.00 per month. Making reasonable assumptions about the drop size and the unit cost of energy, determine if this claim is reasonable. S..

Gas in a piston-cylinder undergoes a carnot power cycle : A gas in a piston-cylinder undergoes a Carnot power cycle. The gas expands and compresses isothermally between two reservoirs at 600 K and 300 K.

User Account

All Pages