Determine the mass flow rate through the compressor

Assignment Help Mechanical Engineering

Reference no: EM13711514

Carbon Dioxide (CO2) gas enters a compressor steadily at 10 KPa and 540K with a velocity of 200m/s. The carbon dioxide leaves the compressor at 3MPa and 900K with a velocity of 40m/s. The exit of the compressor is .006m^2. The heat transfer rate from the carbon dioxide to the environment is 0.8 MW. With the change in kinetic energy considered, determine:

a) the mass flow rate through the compressor

b) the power consumed during the process

Reference no: EM13711514

Questions Cloud

Rate of heat transfer between the steam and cooling water : A shell-and-tube heat exchanger is used to cool a flow of steam using a stream of cooling water. The steam enters the heat exchanger at 0.1 bar and a quality of 91% (state 1), and exits as a saturated liquid at the same pressure (state 2).

Determine the centroidal moment of inertia : Determine the centroidal moment of inertia for the following. The center circle is cut out. you have a rectangle standing up ward the height is 7 in and the width is 4 in there is a cut out hole in the center with 2 in for diameter.

Determine the mass flow rate of air through fan at elevation : A desktop computer is to be cooled by a fan whose flow rate is 0.34 m3 /min. Determine the mass flow rate of air through the fan at an elevation on 3400 m, where the air density is 0.7 kg/m3. The diameter of the casing of the fan, if the average velo..

Calcium silicate has replaced asbestos preferred insulation : Calcium Silicate has replaced asbestos as the preferred insulation for steam lines in power plants. Consider a 40 cm O.D., 4 cm wall thickness steel steam line insulated with a 12 cm thickness of calcium silicate. The insulation is protected from dam..

Determine the mass flow rate through the compressor : Carbon Dioxide (CO2) gas enters a compressor steadily at 10 KPa and 540K with a velocity of 200m/s. The carbon dioxide leaves the compressor at 3MPa and 900K with a velocity of 40m/s. The exit of the compressor is .006m^2. The heat transfer rate from..

For mass-spring-damper accelerometer : For mass-spring-damper accelerometer, calculate the mass needed to achieve mechanical noise limit a_rms = 1 nG if the mechanical resonance frequency is to be f=100 Hz.

Gas in a closed system undergoes the power cycle : Gas in a closed system undergoes the power cycle as shown in the p-v diagram below as described by 1->2 is a constant pressure process, 2-> 3 is a constant volume process and 3 -> 1 is a pV = const. process. The internal energy U1 = U2 = 30 kJ/kg and..

Vertical piston cylinder is heated at constant pressure : Water in a vertical piston cylinder is heated at constant pressure of 10 bar. It is initially at 179.9 0C and has a specific volume of 0.1 m3/kg and is heated to a final specific volume of 0.248 m3/kg. Changes in kinetic and potential energies are ze..

Measured in frequency bands of constant width : White noise has a constant level when measured in frequency bands of constant width. Suppose a noise generator produces white noise over the octave bands 0.5,1,2,4,8 khz. Find the overall un weighted and a-weighted sound pressures if a sound pressure..

User Account

All Pages