### Determine the exiting speeds at each rolling stand

Assignment Help Mechanical Engineering
##### Reference no: EM131341509

A continuous hot rolling mill has two stands. Thickness of the starting plate = 25 mm and width = 300 mm. Final thickness is to be 13 mm. Roll radius at each stand = 250 mm. Rotational speed at the first stand = 20 rev/min. Equal drafts of 6 mm are to be taken at each stand. The plate is wide enough relative to its thickness that no increase in width occurs. Under the assumption that the forward slip is equal at each stand, determine

(a) speed vr at each stand, and

(b) forward slip s.

(c) Also, determine the exiting speeds at each rolling stand, if the entering speed at the first stand = 26 m/min.

#### What is the average magnetic moment per molecule

Consider a material whose molecular electron clouds each have l = 2,s = 1/2; there is no spin--orbit coupling. A mole of this material is at 295 K and in a field of strength

#### Determine the modified coefficient of performance

Over time, dust accumulates on the refrigerator's con- denser coil, which is located behind the refrigerator, increasing the hot side resistance to Rh,d = 0.1 K/W. It is des

#### What is the outer radius

A hollow cylinder steel column of 5 m high is shortens by 0.03 cm under a compression load of 40, 000 kg. If the inner radius of the cylinder is 0.08 of the outer one, what

#### Reversible power cycle operating between hot-cold reservoirs

The thermal efficiency of a reversible power cycle operating between hot and cold reservoirs is 20%. Evaluate the coefficient of performance of a reversible refrigeration cycl

#### Determine final temp and heat transferred during the process

Piston-cylinder assembly contains 3 kg of steam at pressure of 100 bar and temp of 400 C. It undergoes a process by which it expands against a constant pressure of 20 bar, unt

#### Process during which relation between pressure and volume

A closed system consisting of 1 lb of a gas undergoes a process during which the relation between pressure and volume is pV^n = constant. The process begins with p1=20 lbf/in^

#### Calculate enough points and plot a time-temperature graph

A 35lb block of tin is to be heated from room temperature to a relevant temperature for casting, Calculate enough points and plot a time-temperature graph if the heating is

#### Rate of heat transfer to the steam in the reheater

Air enters a compressor at 105 kPa and 300 K with a volumetric flow rate of 12 m3 /min and exits at 1200 kPa and 400 K. Heat transfer occurs at a rate of 2 kW from the compres

### Write a Review 