Reference no: EM131228882
Question 1:
A system of steel pipes is loaded and supported as shown below. If the normal stress in each pipe must not exceed 150 MPa, determine the cross-sectional areas required for each of the sections.
Question 2:
Rigid bar ABC shown below is supported by a pin at bracket A (single shear) and by tie rod (1). Tie rod (1) has a diameter of 5 mm, and it is supported by double-shear pin connections at B and D. The pin at bracket A is a single-shear connection. All pins are 7 mm in diameter. Assume a = 600 mm, b = 300 mm, h = 450 mm, P= 900 N, and ?? = 55°.
Determine the following
a) normal stress in rod (1)
b) the shear stress in pin B
c) the shear stress in pin A
Question 3:
The steel bar shown below will be used to carry an axial tensile load of 400 kN. If the thickness of the bar is 45 mm, determine the normal and shearing stresses on plane AB.
Question 4:
A steel bar with a butt-welded joint, as shown below will be used to carry an axial tensile load of 400 kN. If the normal and shear stresses on the plane of the weld must be limited to 70 MPa and 45 MPa, respectively, determine the minimum thickness t required for the bar.
Question 5:
A 50-mm-wide steel bar has axial loads applied at points B, C, and D. If the normal stress magnitude in the bar must not exceed 60 MPa, determine the minimum thickness that can be used for the bar.
Develop detailed paragraphs that focus on first main point
: Utilizing the worksheet below, develop detailed paragraphs that focus on the first main point for your final paper. For each section, a minimum of one fully-developed paragraph is required.
|
Legal and ethical considerations associated with project
: Your presentation from the previous week was well accepted by the project staff and senior management. The Executive Vice President of Operations asked a question about the legal and ethical issues that are relevant to the contractor dispute. You ..
|
Discussing the current management-organizational behavior
: A five-page (double-spaced) paper discussing the current management and organizational behavior issues within Delta Airlines using management and organizational behavior concepts
|
Explain the risk management process
: Explain the risk management process as it pertains to the fire department. Please use examples to demonstrate your understanding of the risk management process. 200 words in length. APA style?
|
Determine the cross-sectional areas
: ME 255: Strength of Materials - system of steel pipes is loaded and supported as shown below. If the normal stress in each pipe must not exceed 150 MPa, determine the cross-sectional areas
|
Write python program that allow the user to reads contents
: Design an algorithm and use it to write a Python program that allow the user to reads the contents of the data file into a list. The program should then loop, to allow a user to check various numbers against those stored in the list
|
Results of a job evaluation you were the subject
: In a short essay of two or three paragraph, share the results of a job evaluation you were the subject of. Did the supervisor give you adequate notice and invite your opinions, including a self-evaluation? Did you feel the experience was a valid..
|
Is a statement of the boundary conditions
: Hint: Treat this problem as a dielectric slab with a perfect conductor backing, and use the analytical methods of Chapter 9.
|
Analyze the impact of global environmental policy associated
: Analyze the impact of global environmental policy associated with these issues. Devise a 3-5 slide PowerPoint, providing a review of the paper above, present in class.
|