Design circuit containing single op amp to perform operation

Assignment Help Electrical Engineering
Reference no: EM13285775

Design a circuit containing a single op amp that can perform the following operation: Vo= 3x10^4(i2-i1), where i2 and i1 are input current sources.

Reference no: EM13285775

Questions Cloud

Find what is the number of levels used for quantization : 20 s20 signals, each of bandwidth 5 kHz and peak-to-peak range of 4 V, are sampled at their Nyquist rates, quantized uniformly, encoded using PCM, multiplexed in time domain. The multiplexed stream has the rate of 2 Mbps.
These data estimate the number of beans in the jar : To get an estimate of the number of beans in the jar you weigh six beans and obtain masses of 3.15, 3.12, 2.98, 3.14, 3.02, and 3.09 g . Then you weigh the jar with all the beans in it, and obtain a mass of 2082g . The empty jar has a mass of 6..
Explain the total concentration of all ions : When 0.204 moles of (NH4)3PO4 in enough water to make 1.00 L of solution, what is the total concentration of all ions present in solution?
Responsibility upon the shoulders of god or nature : As human beings, we are endowed with freedom of choice, and we cannot shuffle off our responsibility upon the shoulders of God or nature. we must shoulder it ourselves.it is responsibility .Adapted from arnold toynbee.
Design circuit containing single op amp to perform operation : Design a circuit containing a single op amp that can perform the following operation: Vo= 3x10^4(i2-i1), where i2 and i1 are input current sources.
What is the best estimate of stock current market : Why are cash flows that are connected to common stock difficult to estimate? How does this compare to those related to bonds.
Calculate the total mass of sodium chloride : F the volume of ocean water (calculated above) contains 3.3 percent sodium chloride ("salt") by mass and the density of the water is 1.76 g/mL, calculate the total mass of sodium chloride. (1 ton = 2000 lb, 1 lb = 453.6 g)
Explain how many liters of a glucose solution needed : How many liters of a 18.0%(m/v) glucose solution would you need to obtain 160 g of glucose
Should the company replace the old machine : Dauten's marginal federal-plus-state tax rate is 40%, and its WACC is 15%. Should the company replace the old machine?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How much energy does the battery supply to external circuit

A portable battery supplies electricity to an external circuit for 2 hours. The voltage across the terminals of the battery is observed to increase from initial voltage of 5V to 10V (linearly) and the current increases from 1A to 2A (linearly) in ..

  Explain electronic technology in relationship to the use

electronic technology in relationship to the use of personnel and access control, surveillance, and identification of authorized personnel.

  Calculate the percent voltage regulation of the generator

A 60 kVA, three-phase, wye-connected, 440 V, 60 Hz synchronous generator has a resistance of 0.15ohm and a synchronous reactance of 3.5ohm per phase. At rated load and unity power factor, calculate the percent voltage regulation.

  Find the energy absorbed by the element in seconds

the voltage across an element is 12e^-2t V. the current entering the positive terminal of the element is 2e^-2t A. Find the energy absorbed by the element in 1.5 seconds starting from t =0.

  Create a bandpass filter with cutoff frequencies

Create a bandpass filter with cutoff frequencies of 100-1k, attenuate by at least 3db at desired frequency(100-1k) and at 60Hz attenuate by 10 db. Resistor, Capacitor, Inductor, and Op-amps can be used.

  Find what frequency of flying in an ultra-light aircraft

You are flying in an ultra-light aircraft at a speed of 49.8 m/s. An eagle, whose speed is 16.0 m/s, is flying directly toward you. Each of the given speeds is relative to the ground. The eagle emits a shrill cry whose frequency is 3940 Hz.

  How many k-maps would be needed to be solved to design

Given a state diagram with 622 states and 7 input variables, how many K-Maps would be needed to be solved to design the system using T flip-flops

  Find what is real power consumed by the impedance

Find the real power and reactive power dissipated in an impedance Z = 2 ohm at zero degree carrying a current of I = 6 + j8 A. What is real power consumed by the impedance

  Determine the current that would flow in the resistor

If you had the 6V supply set toits full voltage and set so that the maximum supply current is 5A,use Ohm's law to fill in the following two blanks: a. If a 1kOhm resistor wereconnected across the 6V supply's terminals

  Evaluate the step response of h1 and h2

Evaluate the following convolutions using the graphical approach: h1[n]=2u[n+1]-2u[n] h2(t)=2u(t+1)-2u(n) y1[n]={2u[n+1]-4u[n]}*h1[n] y2(t)={r(t-2)-2r(t-4)+r(t-6)}*h2(t) Evaluate the step response of h1[n] and h2(t)

  Design a four pole lowpass filter with sallen-key topology

Design a four pole lowpass filter with Sallen-Key topology and a Butterworth characteristic. The cutoff frequency of the filter must be 16 kHz.

  Explain how to achieve the maximum electric field

A Si (ni = 1 e+10 cm^-3, eps = 11.7) p-n junction is doped with NA = 5.2 e+18 cm^-3 and ND = 8.4 e+14 cm^-3. What reverse bias (the absolute value) should be applied to the junction, in order to achieve the maximum electric field of 3.89E+4 V/cm

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd