Compute the worst voltage regulation and the power factor

Assignment Help Chemical Engineering
Reference no: EM131115385

The following data were obtained on a 25- kVA, 2400:240-V, 60-Hz, single-phase distribution transformer:

• Open-circuit test with meters on LV side: 240 V, 3.2 A, 165 W

• Short-circuit test with meters on HV side: 55 V, 10.4 A, 375 W

Compute the worst voltage regulation and the power factor at which it occurs, when the transformer is delivering rated output at rated secondary terminal voltage of 240 V. Sketch the corresponding phasor diagram.

Reference no: EM131115385

Questions Cloud

What is the necessary condition for a fixed for floating : What is the necessary condition for a fixed-for-floating interest rate swap to be possible?
Determine the all-day efficiency : A transformer has its maximum efficiency of 0.9800 when it delivers 15 kVA at unity power factor.
Analyze the courts reasoning discrepancy has resulted : Although it was conceded by the parties that there was copying in both the Feist case at Feist Publications, Inc. v. Rural Telephone Service Co and the Harper case. Examine and analyze the court's reasoning and elucidate why this discrepancy has re..
How does proactive focus on diversity and inclusion : Global biopharmaceutical company Pfizer believes that a diverse workforce leads to more innovative and creative thinking. The company also feels that inclusion is the foundation to the ownership culture that it wants to build among its employees. Why..
Compute the worst voltage regulation and the power factor : Compute the worst voltage regulation and the power factor at which it occurs, when the transformer is delivering rated output at rated secondary terminal voltage of 240 V. Sketch the corresponding phasor diagram.
Payments into retirement account : How much will you have when you retire in 46 years? How much will you have if you wait 10 years before beginning to save and only make 36 payments into your retirement account?
Analyze and assess communication dynamics of an organization : Analyze and assess the communication dynamics of an organization through the completion of a communication audit.
What conditions a contingent liability should is recorded : 1. Under what conditions a contingent liability should is recorded?
Describe the difference between a swap broker and a dealer : Describe the difference between a swap broker and a swap dealer.

Reviews

Write a Review

Chemical Engineering Questions & Answers

  Determine the maximum frequency of undistorted output

Also determine the maximum frequency of undistorted output that the op amp will produce at an amplitude of 3 V.

  Compute the flux linkage as a function of time

The time-average value of the induced voltage. (e) The induced voltage when the plane of the coil is 30° from the vertical.

  Determining the atmospheric carbon dioxide

A living plant contains approximately the same fraction of carbon- 14 as in atmospheric carbon dioxide. Assuming that the observed rate of decay of carbon-14 from a living plant is 13.6 counts per minute per gram of carbon

  Explain the reasons for changes in flow depth near the hump

Explain the reasons for changes in flow depth near the hump using concepts of specific energy.

  What is the composition of the original solution

A solution that contains nitromethane in acetonitrile is heated at constant pressure of 1 bar until the first bubble appears. If the temperature at this point is 85 °C, what is the composition of the original solution?

  Gravimetric composition and properties

-12 the gravimetric composition and properties of two different typical fuels i.e. coal and fuel oil is tabulated below- Parameters coal fuel oil Composition weight% -- C 76 85 H 4.5 11.5 S 0.5 3.5 N 1.0 -- O 3.0

  Determining the conversion of the reactant

If the feed quality is changed to 80 mol% vapour, the change in the slope of the q-line isA homogeneous reaction (R ® P) occurs in a batch reactor. The conversion of the reactant Ris 67% after 10 minutes and 80% after 20 minutes. The rate equation..

  The final concentration of the dye in the barrel

Into a barrel containing 33.2 bbl (US) of water containing 0.0012 mol/L of a blue dye you pour V2 yd3 of water containing 8.91 M of the dye. The final concentration of the dye in the barrel is 7.91 mol/m3 after it's well-mixed. What is V2 is yd^3?

  Derive closed-loop transfer function relating disturbance

A system can be represented by the block diagram below: Derive (write the different steps explicitly. not just the solution!) the closed-loop transfer function relating the set point (Ysp) to the output Y

  Determine the standard percent return on total investment

determine the standard percent return on the total investment and the minimum payout period.

  Sensitivity analysis on the adipic acid project

Carry out a sensitivity analysis on the adipic acid project described in Example 9.5. Investigate the sensitivity of the 10-year NPV to variation in total fixed capital (-20% to +50%), annual gross profit (-20% to +30%), and project construction s..

  What will be the percentage increase of the radiation

What will be the percentage increase of the radiation coefficient hr under the changed conditions?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd