### Calculate the output for each system for given input

Assignment Help Electrical Engineering
##### Reference no: EM13256714

The signal x(t)=10cos(t)+10sin(10t) is input into the following systems:

a)    \(H(s)=100/(s^{2}+10s+100)\)

b)   \(H(s)=s^{2}/(s^{2}+10s+100)\)

calculate the output for each system.

#### Design a sequential circuit that continuously computes

design a sequential circuit that continuously computes the function 2X + 3 or 3X + 1 where the variable X is a three-bit unsigned integer available on a serial interface. A

#### Create an hla program to perform two data conversions

Using Floating Point Unit and the switch statement Create an HLA program to perform the following: -Two data conversions (decimal,binary,hex) -Two measurement calculations (mi

#### Simplify the equations using a k-map and draw final circuit

Write the full equations to light the bottom segment of a 7-segment display. INLCUDE the hexadecimal digits too ( b, c, d, and E ). Then simplify the equations using a k-map

#### Find the induced emf and the armature current of generator

In a 120V compound generator, the resistances of the armature shunt and series windings are 0.06 ohm, 25 Ohm, and 0.04 Ohm respectively. The load current is 100A at 120V, fi

#### Determine the total armature power developed when working

A 25KW, 250V dc shunt generator has armature and field resistances of 0.06 ohm and 100 ohm respectively, determine the total armature power developed when working (1) as a g

#### Find the average power delivered the resistor

when an AC source is connected accross a 12.0 resistor,the rms current in the resistor is 8.00 A find (a) the rms voltage accross the resistor,(b) the peak voltage of the s

#### What is the maximum load possible without a heat sink

A small buck converter has 24 V input and 12 V output. The transistor has Rds(on) - 0.1 Ohm. The diode is modelled as a 1.0 V drop. Each device has junction to ambient Rthet

#### Find what is the switching loss in the transistor

A boost converter has 5 V input and 12 V output at 60 W. The diode is ideal. The transistor requires 1 us to turn on and off. The switching frequency is 100 kHz. The storage